Chapter § Additional Information; Specifications - Sony CDP-C445 Operating Instructions Manual

Chapter 5 Additional information
Maintenance Specifications
i C ct Disc Pi
Cl - Pi ompa sc Player
an crept a eal E
; vak : Laser Semiconductor laser
Clean the cabinet, panel and controls. with a soft cloth lightly
Wavelength
780-790 nm
moistened with a mild detergent solution. Do not use any
type of abrasive pad, scouring powder or solvent such as
alcohol or benzine.
Frequency response 2 Hz-20 kHz (+0.5 dB)
Signal to noise ratio More than 107 dB
Dynamic range More than 98 dB
Harmonic distortion Less than 0.0035%
Channel separation More than 100 dB
Cleaning Discs
Outputs
LINE OUT Output level 2 V
When a disc becomes dirty, clean it with a cleaning cloth.
(phono jacks)
Load impedance over 10 kilohms
Wipe the disc from the center out.
DIGITAL OUT
Wave length 660 nm
(OPTICAL) Output level -18 dBm
(optical output
connector)
PHONES Output leve! max. 10 mW
(stereo phone jack) Load impedance 32 ohms
General
Power requirements Model for the USA and Canada
120 V AC, 60 Hz
Model for Australia
240V AC, 50/60 Hz
Power consumption 14W
Remote Commander RM-D335
Remote control system Infrared control
Power requirements 3 V DC with two size AA batteries
(IEC designation R6)
Dimensions 45 x 20 x 185 mm (w/h/d)
(1'6 x "/16 x 7/8 inches)
Mass 100 g {3.5 02) including batteries
Design and specifications are subject to change without
notice.
25