Table of Contents
Advertisement
Additional information
Rae
A
A
Precautions
On safety
As the laser beam used in the CD
player section is harmful to the eyes,
do not attempt to disassemble the
casing. Refer servicing to qualified
personnel only.
Should any solid object or liquid fall
into the player, unplug the player, and
have it checked by qualified personnel
before operating it any further.
On power sources
¢ For AC operation use the supplied AC
power cord; do not use any other type.
¢ The player is not disconnected from
the AC power source (mains) as long
as it is connected to the wall outlet,
even if the player itself has been
turned off.
Unplug the player from the wall outlet
when it is not to be used for an
extended period of time.
For battery operation, use six size D
(R20) batteries.
When the batteries are not to be used,
remove them to avoid damage that
can be caused by battery leakage or
corrosion.
The nameplate indicating operating
voltage, power consumption, etc. is
located at the rear.
On placement
* Do not leave the player in a location
near heat sources, or in a place subject
to direct sunlight, excessive dust or
mechanical shock.
Do not place the player on an inclined
or unstable place.
Do not place anything within 10 mm
of the side of the cabinet. The
ventilation holes must be
unobstructed for the player to operate
properly and prolong the life of its
components.
If the player is left in a car parked in
the sun, be sure to choose a location in
the car where the player will not be
subjected to the direct rays of the sun.
Since a strong magnet is used for the
speakers, keep personal credit cards
using magnetic coding or spring-
wound watches away from the player
to prevent possible damage from the
magnet.
On operation
If the player is brought directly froma
cold to a warm location, or is placed in
a verv damp room, moisture may
condense on the lens inside the CD
player section. Should this occur, the
plaver will not operate properly. In
this case, remove the CD and wait
about an hour for the moisture to
evaporate.
If the plaver has not been used for a
long time, set it in the playback mode
to warm it up for a few minutes before
inserting a cassette.
If vou have anv questions or problems
concerning your player, please consult
your nearest Sonv dealer.
continued
Additional Information
21
Advertisement
Table of Contents
