Playing In A Specified Order - Program Play - Sony CDP-C445 Operating Instructions Manual

Playing in a Specified Order — Program Play
Program play allows you to specify the order of discs or selections to be played. You
can program up to 32 "steps" in the order you specify. One "step" may contain one
selection or a whole disc. You can check the total playing time while programming
the selections.
Program Play
1 Place discs in the disc compartments,
then press 4.
"PROGRAM" appears in the display.
~ If a program has been previously stored, it is
recalled. if you do not need the program, hold
down CLEAR to erase it (page 15).
3-A To program discs in the order you want
play
Press DISC 1-5 in the order you want to
program.
"AL" appears in the display.
-= If you use DISC SKIP instead of DISC 1-5 to
choose the disc, press PROGRAM after that.
3-B To program selections on a disc in the order
you want to play
Before you program selections, specify the disc by
pressing DISC 1-5. There are two ways to program
selections.
coe
1) Use the numeric buttons to choose
selections in the order you want to program.
Current disc Chosen Total playing time
selection
"AL' in the display disappears, then the selections
you choose will be programmed. Each time you
choose a disc or a selection, the playing time is
added to the total playing time. You can check the
total playing time while programming.
— To enter a selection number greater than 10,
see page 10.
— If you enter the wrong numbers:
Each time you press CLEAR, the last entered
number will be deleted.
— To program the selection(s) on another disc,
press DISC 1-5 to change the disc, then
program selections.