Tricity Bendix 3000S Operating And Installation Instructions page 22

CLEANING THE SEALED PLATES
Whilst the plate is still warm, but not hot wipe
over with a damp cloth to prevent stains being burnt
on and becoming difficult to remove.
Clean the stained and badly soiled areas of the
plate with a scourer made especially for non-stick
saucepans with a cream cleaner, e.g. Flash, Jif or
Ajax.
Clean the plates and trims with a damp cloth and
a non-scratch cream cleaner, which is also suitable
for stainless steel and chrome, e.g. 'Luneta'.
The plate trims will mellow in use. A stainless
steel cleaner used regularly will help maintain a
bright appearance.
Wipe with a clean damp cloth to remove any
excess cleaner and dry with a kitchen towel.
SWITCH ON THE PLATE FOR 30 SECONDS
TO ENSURE THAT THE PLATES ARE
THOROUGHLY DRY.
To help maintain the original black appearance of
the plate surface a thin coat of cooking oil e.g. Collo
Electrol may be applied occasionally. This will
smoke and produce some fumes the next time the
plate is used.
CLEANING THE GRILL
It is essential to keep the underside of the
removable vitreous enamel grill deflector absolutely
clean. After grilling, thorough cleaning of the surface
with a soap impregnated steel wool pad is advised.
The deflector can be removed by opening the
grill compartment door. Clean the grill pan in a
similar manner.
When replacing the grill deflector make sure it is
in position immediately above the grill element, with
the front lip down.
22
CLEANING THE FAN OVEN
'Stay-Clean' panels have been fitted to this oven,
instructions for cleaning these panels are given
under 'Care of Stay-Clean'.
The vitreous enamel oven base may be cleaned
using normal oven cleaners.
Oven shelves if heavily soiled will wipe clean if
first soaked in hot soapy water.
NOTE
If aerosol cleaners are used on any part of the
cooker the manufacturer's instructions must be
followed, and it is recommended that all parts are
well rinsed afterwards.
Aerosol cleaners must not be used on 'Stay-
Clean' liners, and must not be allowed to come
into contact with the elements as this may cause
damage.