Tricity Bendix TM 330 Operating And Installation Instructions page 6

Hide thumbs Also See for TM 330:

Table of Contents

4.4

Select correct heat position (see programme chart on facia panel).

Set the timer to the correct position (see programme chart on facia panel).

The drum will now begin to rotate and stop when the timer automatically reaches

the 'O' position.

Should the clothes become dry before the cycle has finished the sensordry

thermostat will automatically switch off the heater and prevent overdrying and

save energy although the drum will still rotate.

There is an automatic 12 minute cool down period at the end of every cycle,

during which the heater is switched off. This helps to minimise creasing.

4.5

When drying large items such as sheets, we suggest you stop the dryer to

redistribute the load.

Tp stop the machine during the middle of the programme simply open the door;

the drum will stop rotating automatically and restart when you close the door.

To lengthen or shorten the programme, turn the timer knob.

4.6

After removing the dried clothes clean the filter as follows:

— Pull the filter upwards.

— Remove any thread or fluff by hand or with a soft brush.

— Slide the filter back.

—Wash the filter occasionally in detergent solution and with a soft brush remove

small particles.

— Disconnect from the electricity supply.

Care labels you may find on your fabrics

■

■■

Tumble drying beneficial'

■

'Do not tumble dry'

'Dry flat'

Table of Contents