Canon HG10 Instruction Manual page 39

I[XJ
(CD 24)
To
ADJUST THE VOLUME OF THE
HEADPHONES
In (CAMERA''') mode, adjust the volume
of the headphones with the [PHONES
VOL.] setting (CD 50). In
~
mode, use the navigation buttons and
the function guide following the same
procedure as when adjusting the
speaker's volume.
~
0»)
1~~<i"~~1
0>
FUMC.
(0]26)
1
Press
!ruNc·l.
2
Use the navigation buttons to
select the
I!tiilJ
icon and press
@
to open the setup menus.
3
Press. or
T
to select [SYSTEM
SETUP] and press
@.
4
Press • or
T
to select
[AV/PHONES] and press
@.
5
Press
T
to select
[0
PHONES]
and press
@.
6
Press
IFUNC·I.
o
appears.
o
IMPORTANT
• Do not connect the headphones to the
AV OUTIO terminal if the
0
icon does
not appear on the screen. If you connect
the headphones while the terminal is set
to AV output, only noise will be output.
• When using headphones, make sure to
lower the volume to an appropriate
level.
• The sound of the built-in speaker will be
muted when you close the LCD panel,
when you connect the STV-250N Stereo
Video Cable to the AV OUTIO terminal
or when [AV/PHONESI is set to
[0
PHONES].
CD
NOTES
• Use commercially available headphones
with a 0 3.5 mm minijack.
• When you turn off the camcorder or
change the operating mode, the
[AV/PHONES] setting in (PlAY,"') mode
will return to
[I
AV
I AV).
• The volume of the headphones cannot
be adjusted while recording.
39
I[XJ
(CD 24)
To
ADJUST THE VOLUME OF THE
HEADPHONES
In (CAMERA''') mode, adjust the volume
of the headphones with the [PHONES
VOL.] setting (CD 50). In
~
mode, use the navigation buttons and
the function guide following the same
procedure as when adjusting the
speaker's volume.
~
0»)
1~~<i"~~1
0>
FUMC.
(0]26)
1
Press
!ruNc·l.
2
Use the navigation buttons to
select the
I!tiilJ
icon and press
@
to open the setup menus.
3
Press. or
T
to select [SYSTEM
SETUP] and press
@.
4
Press • or
T
to select
[AV/PHONES] and press
@.
5
Press
T
to select
[0
PHONES]
and press
@.
6
Press
IFUNC·I.
o
appears.
o
IMPORTANT
• Do not connect the headphones to the
AV OUTIO terminal if the
0
icon does
not appear on the screen. If you connect
the headphones while the terminal is set
to AV output, only noise will be output.
• When using headphones, make sure to
lower the volume to an appropriate
level.
• The sound of the built-in speaker will be
muted when you close the LCD panel,
when you connect the STV-250N Stereo
Video Cable to the AV OUTIO terminal
or when [AV/PHONESI is set to
[0
PHONES].
CD
NOTES
• Use commercially available headphones
with a 0 3.5 mm minijack.
• When you turn off the camcorder or
change the operating mode, the
[AV/PHONES] setting in (PlAY,"') mode
will return to
[I
AV
I AV).
• The volume of the headphones cannot
be adjusted while recording.
39