Recharging The Pbp-1 Battery Pack - JVC TM-41 EG Service Manual

2. Insert the battery pack with its cord outward and Power Adapter can recharge two PBP-1. battery packs
the blue ribbon on top of the battery pack. simultaneously; one installed inside the monitor and the
other separate from the unit — a spare battery.
ee : 1. Plug the provided power cord into the AC IN
terminal of the AA-P41EG/EK/S. Connect the AC
Power adapter to an AC power supply.
2. When the battery pack installed within the
monitor is to be recharged, connect the DC output
cable of the adapter to the DC IN 12 V/CHARGE
connector,
3. The monitor should be set to OFF. The battery
cannot be recharged unless the OFF/VOLUME
3. Plug the battery cord into the socket near the
opening and replace the cover,
Fig. 1-8
4, When a spare battery pack is to be recharged
simultaneously, connect the PBP-1 battery pack to
the EXT BATTERY terminal of the adapter,
— ca
If the BATT ALARM indicator should tight red
after installing the battery pack, recharge or
replace the battery pack with a fresh one, A
battery pack running out of power should be
recharged immediately.
Fig. 1-9
1.8 RECHARGING THE PBP-1 BATTERY PACK 5. Set the adapter's power switch to ON. Recharging
will begin.
The AA-P4TEG/EK/S AC Power Adapter is required to 6. Check the charging condition with the meter
rechange the exclusive PBP-1. The AA-P41EG/EK/S AC provided on the adapter.
Fig. 1-7