Table of Contents
Advertisement
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION / OPERATION INSTRUCTIONS
PIZZA PREP TABLES
Step 4
A. Remove rear grill and thread electric cord
through grommet in grill.
B. Replace grill.
C. Align cutting board with rivnuts and attach
retainer clip to table top (figure 1).
D. Install the lid brackets. Note that there is a
specifically designed left, center (if applicable), and
right bracket.
ANCHORING THE TSSU HOOD COVER
Step 5
TSSU Hood Installation Instruction
A. Remove rear grill and thread electric cord This is
True's recommended procedure for installing the
fasteners required to connect the sandwich salad
hood cover to the hood.
See callout #1 on the illustration.
Assembly
1. Locate the hood cover, (packaged within the
cardboard container on top of the salad sandwich
unit), and position under the hood.
2. Remove the slotted thumb screw from hood by
backing out the factory installed, slotted thumb
screw. See diagram of slotted screw and callout #2.
3. Place hood cover into final position, (beneath
hood), align hood hinge pin with anchor hole on
hood cover and re-attach fastener by replacing
thumb screw into hinge pin.
4. Repeat procedure for both ends of hood.
6
6
............ www.truemfg.com ............
............ www.truemfg.com ............
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
RETAINER
CLIP
CUTTING BOARD
TABLE TOP
HOOD
HINGE PIN
3
FASTENER ASSEMBLY
Figure 1.
1
SLOTTED THUMB SCREW
2
HOOD COVER
6
6
Hide quick links:
Advertisement
Table of Contents
