Locating & Installation Of Leg/Castors - True TUC-27G Installation Manual

True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION / OPERATION INSTRUCTIONS
LOCATING
Step 2
A. Place packing material behind cabinet as a
cushion. Carefully lay the unit on its back to
remove skid.
When lifting unit remember to
leave the cabinet upright for 24 hours before
plugging into power source.
INSTALLATION OF LEGS AND CASTORS
Important Safeguard for installation of leg/castor (Images 1-5 demonstrate procedure)
Step 3
Securing Castors and Legs
To obtain maximum strength and stability of the
unit, it is important that you make sure each castor
is secure. Legs are hand-tightened securely against
the lower rail assembly. The bearing race on the
castor of the top edge of the leg must make firm
contact with the rail.
Unit leveling
Four leveling shims have been provided for level-
ing castored units positioned on uneven floors.
Shims must be positioned between rail end and
bearing race. True requires a four shim limit to
each individual castor.
A. Turn the bearing race counter-clockwise until
the cabinet is level. Level front to back and side to
1
Thread castor into the under-
side of cabinet frame rail.
5
The end of the leg is
adjustable to easy leveling.
5
5
2
For leveling, insert the shim
between the castor and frame rail.
............ www.truemfg.com ............
............ www.truemfg.com ............
B. Remove skid by unscrewing all base rail anchor
brackets. Place skid to the side.
C. Carefully lift cabinet upright.
Removing
skid from
bottom of
cabinet.
side. (diagonally)
B. Install the desired number of shims, making sure
the slot of the shim is in contact with the threaded
stem of the castor.
C. If more than one shim is used, turn the slot at a
90° angle so they are not in line.
D. Turn the bearing race clockwise to tighten and
secure the castor by tightening the anchoring bolt
with a 3/4 inch open-end wrench or the tool
provided.
CAUTION
To avoid damage to lower rail assembly,
slowly raise unit to upright position.
3
Use the tool provided to
tighten the castor into place.
4
Thread leg into cabinet
bottom frame rail.
5
5