Technics SL-PD887 Operating Instructions Manual page 9

You can program up to 32 selections from the five discs in any
order as you desire.
2 5 1
-f # PROGRAM MOO
MODE [In the stop mode]
□
Press PROGRAM MODE so
^ that the "PGM" indicator
illuminates.
Each time the button is pressed, the
display wiil change in the following
order:
PGM - DEL ^ (off).
/ n n
I /; u
C. f_flR
DQC No.
Illuminates
/
Press the desired disc but*
ton (1 —5).
OIKI aK2 MCI DMCt OtC)
For example:
O O O O O
To select disc 3. press DISC 3.
'-/ <:7>.
lose' 'met No-
Specified disc number
The "AL" indication shows that ali the tracks
on the disc are selected.
To program by means of disc numbers oniy.
repeat the above operation. (The count will in¬
crease by one for each operation.)
} Press the numeric button(s)
12 0 >10
to specify the track number.
CD CD SSCDCb For example:
To select track number 20, press
>10, then 2. and then 0.
I XT
jn ]
I f > oic /_/Tiua No. I
Repeat steps 2 and 3 until you have
completed the desired entry.
If you enter non-existing disc(s) or track(s) soon after
the loading drawer is closed or when it is open, the
corresponding indicator illuminates and the entry is
included in the count. In the play mode, the changer
will cancel the non-existing entry.
W'*/> C W ^
II Zi -I
I 9 ft
I
fmcK No. "
If you attempt a 33rd selection, the " -F" (full) indica¬
tion will be displayed.
Press ^ to start play.
To enter additional selections during
play, repeat steps 2 and 3.
To dear the entire programmed contents
[in the stop mode]
Press ■.
To cancel program mode
program mode
[In the stop mode]
I Press PROGRAM MODE twice.
The changer will return to sequential play
mode.
The programmed contents will remain stored in the memory until
they are cleared, even after the program mode is canceled.
Therefore, after using program play, it is possible to cancel the
program mode and use another play mode (except delete play)
and then still use the same program play again at a later time,
in addition, if the disc is replaced with another one, program play
will be carried out using the new disc. If non-existing entries oc¬
cur at this time, they will be canceled.
For your reference:
The program mode and the programmed contents will remain
stored in the memory even after the unit is switched off.
However, if the power cord is unplugged or the power supply is
otherwise interrupted for an extended length of time, the con¬
tents of the memory will be erased.
Specified track number Programmed
order