Table of Contents
Advertisement
Messages on the MDR LED display
Display
Description of the Messages
| QE
| No disk is installed. install a disk.
EF nr t
The installed disk is not formatted. Format the disk. (See page 2.)
B ro t
1) The installed disk is write-protected, so the Record, Song Copy, and Song Delete jobs cannot be performed.
Set the disk's Write Protect tab to the OFF position. (See page 1.)
2) If you are using a copy-protected playback-only disk, this message may appear when you attempt the Record,
Song Copy, or Song Delete operations.
B
Е u L L
1) The disk's memory capacity is full, so the Record or Song Copy operation cannot be performed. Install
another formatted disk.
2) Data is already recorded at all song numbers, so the Song Copy operation cannot be performed. Press the
STOP button, then delete any unnecessary songs.
r п t ч
None of the song numbers contain recorded data, so the Song Copy operation cannot be performed. Press the
т,
STOP button.
au
t
An error occurred because the disk was removed during recording or playback. Replace the disk, press the
STOP button, then start the operation over again.
d ( £ E
The installed disk cannot be played back on the M.D.R. Press the STOP button, then insert a compatible disk.
L a t 5
Recording cannot be performed because too much data was received at once. Press the STOP button.
hRd
The disk is defective and cannot be formatted. Press the STOP button, then insert another disk.
E rar
An error occurred during the transmission or reception of data. Press the STOP button.
aana
In the case of Voice Disk operation, an incompatible Voice Disk has been inserted.
Troubleshooting
Problem
Possible Cause and Solution
Recording or playback cannot be
1) Problems in recording or playback may be caused by improper operation of the M.D.R. Refer
performed.
to the LED Display Messages chart above.
2) The PLAY or RECORD section buttons for selecting parts may be turned off. Turn on the
appropriate PLAY or RECORD buttons.
A total of 40 songs cannot be
If some song numbers contain a large amount of recorded data, the disk may not have enough
recorded.
available memory left to record the normal maximum of 40 songs.
Recording is stopped before the
The amount of recorded data on the disk is close to the maximum limit. Either use another disk or
performance is finished, or the
delete the data of any unnecessary song number. (See page 15.)
Song Copy function cannot be
executed.
In addition to a recorded
|
1) When recording, you forgot the following operation: press the RECORD button, then hold
performance on the Upper and/or
down the SHIFT button while you press the UPPER button (selecting Lead).
Lower keyboards, a performance
2) During playback, you forgot to set the LEAD PLAY button to on.
using a Lead voice cannot be
recorded or played back.
The Keyboard Percussion part has
When recording, you forgot the following operation: press the RECORD button, then hold down
not been recorded, or plays back a
the SHIFT button while you press the PEDAL button (selecting Keyboard Percussion). Other
different rhythm from the one
causes may be involved, so refer to the procedure for recording parts separately. (See page 6.)
recorded.
The rhythm does not start at the
The M.D.R. is designed so that the rhythm cannot be started at the very beginning of a recording.
beginning of a recording, or stops
If you wish to use the rhythm, start it after the available memory display appears on the M.D.R.
in the middle of the performance.
display.
The notes of the recording are
During playback, you removed the disk by pressing the EJECT button. Whenever you wish to
"stuck" and sound continuously.
stop playback, always press the STOP button.
FLOPPY DISK PRECAUTIONS
Floppy disks contain magnetic particles, which are used to store data. Observe the following precautions when handling and storing the disks.
* Do not place the disks close to sources of magnetic fields, such as speakers and television sets.
* Do not drop the disks, fold them, or apply excessive pressure to them.
* Do not open the shutter or touch the surface of the disk itself.
* Do not subject the disk to direct sunshine or high or low temperature extremes.
18
Advertisement
Table of Contents
