Table of Contents
Advertisement
5
Transport, packaging, storage
5.1 Transport
Check the mobile fan after delivery for visible transport
damage. If you discover any damage, immediately report
it to the transport company or the dealer.
NOTE!
Protect the device from moisture.
5.2 Packaging
All packaging materials and packaging aids used are
recyclable and must always be recycled.
Packing components made of cardboard are shredded
for waste paper collection.
The foils are made of polyethylene (PE), the upholstery
parts made of polystyrene (PS). You can hand over
these substances to a recycling center or to the disposal
company responsible for you.
5.3 Storage
Clean the mobile fan, oil the bearings and store it in a
frost-free and dry environment. Do not put anything on
the fan.
MV-Series | Version 2.01
Transport, packaging, storage
6
Operation
Use protective gloves!
Wear protective clothes!
DANGER!
Danger to life through electric
shock!
Contact with live components may result in fatal
injury.
CAUTION!
Risk of crushing!
Incorrect work on the fan may cause injury to fingers
and hands.
Never insert your fingers into the protective grille of
the impeller!
ATTENTION!
- The device is not to be used in potentially explosive
atmospheres.
- The device must not be operated in humid work-
places or outdoors in wet conditions.
- Observe mains voltage! The voltage of the current
source must correspond to the information on the
type plate (Fig. 2).
- Make sure that the ON/OFF switch is off when
connecting to the mains.
Step 1: Set up the device at the location where you want
it to be used.
Step 2: Set the desired fan angle with the locking screws
(models MV 50, MV 60 and MV 80). Setting
angles are possible from -30° to +90°.
Fig. 5: Adjusting the setting angles
Step 3: Plug the mains plug into the socket and switch on
the fan.
7
Advertisement
Table of Contents
