Changing The Saw Disc (See Fig . F); Getting Started; Switching On/Off; Working Procedures - Parkside PFDFA 20-Li A1 Translation Of The Original Instructions

Changing the saw disc (see fig . F)
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
♦ Set up the appliance so that the rear side of
the blade guard 3 is facing towards you .
♦ Undo the screw k on the rear of the blade
guard 3 using a Phillips screwdriver (not
supplied; see fig . G) .
♦ Pull the blade guard forwards off the appliance .
♦ Press the spindle lock f and keep it pressed .
Check whether the saw disc j still turns . If yes,
turn the saw disc j until the spindle lock f
clicks into place .
♦ Insert the face spanner q into the corresponding
holes on the flange h . Undo the flange h using
the face spanner q by turning it in the direction
indicated by the arrows on the saw disc j and
the appliance .
♦ Remove the flange h and the saw disc j from
the spindle .
♦ Insert the new saw disc and check that the
direction of rotation is correct using the arrows
on the disc and device (direction of rotation
arrow ) .To reassemble, proceed in reverse
27a
order .
■ Before use, check to ensure that the blade
guard 3 closes properly . When the saw
disc j retracts from a cut, it must retract
completely into the blade guard 3 .
■ Always carry out a test run without load before
starting work and after replacing an accessory
tool . Switch off the product immediately if the
accessory tool runs unevenly, if there is a signifi-
cant vibration or if you hear unusual noises .
PFDFA 20-Li A1

Getting started

WARNING!
■ Never activate the spindle lock f while the
saw disc j is still turning .
■ Before use, check to ensure that the blade
guard 3 closes properly . When the saw
disc j retracts from a cut, it must retract
completely into the blade guard 3 .
■ Keep your hands out of the sawing area and
away from the saw disc j while the appli-
ance is switched on!

Switching on/off

Switching on
♦ Push the ON/OFF switch y forwards until it
clicks into place .
Switching off
♦ Press the rear part of the ON/OFF switch y .

Working procedures

♦ Always use both hands to hold the appliance
while you are working . Use the additional
handle 1 to have optimum control over the
appliance .
♦ Make sure that you apply an even force to
saw even slots .
♦ Do not apply the running saw disc j to the
workpiece until the appliance has reached full
speed . Otherwise, this could cause a kickback .
♦ Select a biscuit that is appropriate to the materi-
al thickness . Choose the largest one possible to
ensure optimal stability . You can also use sever-
al biscuits on top of each other .
♦ Mark the centre of the groove that you want to
mill on the workpiece with a pencil (not supplied) .
Apply the appliance with the groove marking c
at the marked position (see fig . M) .
GB │ IE │ 9 ■