Table of Contents
Advertisement
Canadian Department of Communications Compliance Statement
This equipment does not exceed Class A limits per radio noise emissions for digital apparatus, set out in the
Radio Interference Regulation of the Canadian Department of Communications. Operation in a residential
area may cause unacceptable interference to radio and TV reception requiring the owner or operator to take
whatever steps are necessary to correct the interference.
Avis de conformite aux normes du ministere des Communications du Canada
Cet equipement ne depasse pas les limites de Classe A d" emission de bruits radioelectriques pour les appareils
numeriques, telles que prescrites par le Reglement sur le brouillage radioelectrique etabli par le ministere des
Communications du Canada. L' exploitation faite en milieu residentiel qeut entrainer le hrouillage des
receptions radio et tele, ce qui obligerait le proprietaire
OU
l" operateur
a
prendre les dispositions Necessaires
pour eliminer les causes.
Federal Communications Commission (FCC) Statement
Warning: This equipment generates, uses, and can radiate radio frequency energy and if not installed and
used in accordance with the instruction manual, may cause interference to radio communications. It has been
tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15
of FCC rules, which are designed to provide reasonable protection against such interference when operated in
a commercial environment. Operation of this equipment in a residential area is likely to cause interference in
which case the user at his own expense will be required to take whatever measures may be required to correct
the interference.
Instructions to User: If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the device with respect to the receiver.
• Move the device away from the receiver.
• Plug the device into a different outlet so that device and receiver are on different branch circuits.
Properly shielded and grounded cables and connectors must be used for connection to peripherals in order to
meet FCC emission limits. Proper cables are available from IBM authorized dealers. IBM is not responsible
for any radio or television interference caused by using other than recommended cables or by unauthorized
modifications to this equipment.
It
is the responsibility of the user to correct such interference.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional
suggestions. The user may find the following booklet prepared by the Federal Communications Commission
helpful:
How to Identify and Resolve Radio-TV Interference Problems
This booklet is available from the following:
Consumer Assistance and
Small Business Division
Room 254
1919 M St. NW
Washington, DC 20554
Tele (202) 632-7000
FOB Public Contact Branch
Room 725
1919 M St. NW
Washington, DC 20554
Tele (202) 634-1940
The United Kingdom Telecommunication Act 1984
This apparatus is approved under approval number NS/G/23/J/100003 for indirect connections to the public
telecommunications systems in the United Kingdom.
iii
Advertisement
Table of Contents
