Table of Contents
Advertisement
Operating Problems
Numerous checks were carried out on your appliance be-
fore it left the factory. However, should you notice a mal-
Problems
The washing machine
doesn't start or doesn't fill:
The appliance fills but emp-
ties straight away:
The washing machine
doesn't rinse or doesn't emp-
ty:
You have found water around
the washing machine:
Wash is unsatisfactory:
The appliance vibrates, is
noisy:
• the appliance isn't plugged in correctly, the electrical installation isn't working,
there is a power failure,
• the lid of your appliance and the drum shutters aren't closed firmly,
• the programme start command hasn't been properly selected,
• the water supply has been cut off, the water inlet tap is closed,
• the water inlet filters are dirty,
• a red tab appears on the water inlet hose.
• the drainage U-piece is fixed too low (see installation section).
• the drain hose is blocked or bent,
• the object trap is obstructed,
• the out of balance detector has been activated : washing is unevenly distributed
in the drum,
• the "Drain" programme or "Night Silence Plus" or "Rinse hold" option have been
selected,
• the height of the drainage U-piece is unsuitable.
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn't attached correctly,
• the water inlet hose is leaking.
• the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
• all packaging have not been removed from the appliance (see installation section),
• the appliance isn't level and is unbalanced,
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum, the load is too small,
• the appliance is in running in period.
function, please refer to the sections below before con-
tacting the after-sales service.
Causes
7
Advertisement
Table of Contents
