JVC KD-G320 Instructions Manual page 120

ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting:
Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
To external components (see diagram
Rear ground
Line out (see diagram
Antenna terminal
* 2 Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise
power cannot be turned on.
White with black stripe
Left speaker (front)
B
Connecting the external amplifier or subwoofer
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Set "L/O MODE" to "REAR" (See page 13 of the INSTRUCTIONS.)
You can connect a power amplifier for rear speakers.
JVC Amplifier
C
Connecting the external components
®
CD changer, Apple iPod , or JVC D. player
• Set "CHANGER" for the external input setting (See page 13 of the INSTRUCTIONS.)
You can connect these components as illustrated below.
The iPod* 5 or D. player can be connected using an interface adapter (not supplied)—
KS-PD100 (for iPod) or KS-PD500 (for D. player).
CD changer jack
Other external component
• Set "EXT IN" for the external input setting (See page 13 of the INSTRUCTIONS.)
CD changer jack
Instal1-2_KD-G424_002A_1.indd 2 Instal1-2_KD-G424_002A_1.indd 2
All manuals and user guides at all-guides.com
)
15 A fuse
)
Black
*
Yellow 2
Red
Blue
Blue with white stripe
White Gray with black stripe
Right speaker (front)
Remote lead
Remote lead (Blue with white stripe)
Rear speakers
JVC CD changer
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
Gray Green with black stripe
Y-connector (not supplied for this unit)
To the remote lead of other equipment or automatic antenna if any
Front speakers
Apple iPod
(separately purchased)
or
JVC D. player
(separately purchased)
External component
External component
3.5 mm stereo mini plug
2
* 1
Not supplied for this unit.
Ignition switch
Fuse block
To the remote lead of other equipment (200 mA max.)
Green Purple with black stripe
Left speaker (rear)
* 3
Firmly attach the ground wire to the metallic body or to
the chassis of the car—to the place uncoated with paint (if
coated with paint, remove the paint before attaching the
wire). Failure to do so may cause damage to the unit.
* 4
Signal cord (not supplied for this unit)
Set "L/O MODE" to "WOOFER" (See page 13 of the INSTRUCTIONS.)
You can also connect a subwoofer to the REAR LINE OUT
terminals.
JVC Amplifier
Subwoofer
CAUTION :
• Before connecting the external
components, make sure that the unit is
turned off.
* 5 iPod is a trademark of Apple Computer,
Inc., registered in the U.S. and other
countries.
* 6
Connecting cord supplied for your CD
changer
* 7
Line Input Adapter KS-U57 (not supplied for this unit)
*
8 AUX Input Adapter KS-U58 (not supplied for this unit)
Purple
Right speaker (rear)
11/28/05 2:11:02 PM 11/28/05 2:11:02 PM