Table of Contents
Advertisement
Connect a MIDI rhythm machine (such as the RX7) to the
YMC1O
and
multi-track
tape
recorder
(such as the
МТ100) as shown.
Set the YMC10 mode switch to MIDI IN.
Begin recording on tape (track 1), and start the RX7.
. CAUTION -
e When
recording
the sync
signal, set the recording
volume on the MT100 so that the MT100 level meter
will read about OVU.
|
e When
in MIDI IN mode, there will always be a steady
tone sent from the TAPE
OUT jack. When
the song
begins, the steady tone will change to a warble, and
tone. There is no need to listen to this, but it can be a
useful checkpoint.
|
m
——À.
when the song is over, it will change back to a steady . |
[1] Set the YMC10 mode switch to TAPE IN.
Set the RX7 sync to MIDI CLOCK. (See the RX7 owners
manual.) Play the tape, and the RM7 will begin playing in
sync with the tape.
|
(If you use the MT100 pitch control to change the tape
speed, the RX7 tempo will change accordingly.)
"CAUTION...
e
Before playback, be sure to rewind the tape to a bit
before the point where the tape sync signal starts.
When using other MTR equipment to record and reproduce the
sync signal, be sure the recording level is correct.
Otherwise, it may not sync. Also, some equipment may reverse
the phase of the sync signal, making synchronization impossi-
ble.
|
Advertisement
Table of Contents
