Table of Contents
Advertisement
Mounting the Radar
Before you mount the radar, you must review the mounting location considerations and select a mounting
location.
NOTE: The supplied M8 x 1.25 x 60 threaded rods can be used on mounting thicknesses of 5 to 30 mm (
3
1
/
in.) (recommended). For surfaces over 30 mm (1
16
1 If you are not installing the device on a pre-drilled Garmin compatible radar mount, use the included
mounting template to drill four 9.5 mm (
2 Connect the power cable to the power port
3 Press the cables into any of the guide grooves
hold-down plate
.
The cables should be bent or twisted as little as possible.
4 Using the arrow on the bottom as a reference, position the radome on the mounting surface aligned to the
front of the vessel.
NOTE: If you choose not to align the dome with the front of the vessel, you can adjust the front-of-boat offset
after the dome is installed
5 Apply the included anti-seize compound to the threads of the four M8 x 1.25 x 60 threaded rods.
6 Insert the four threaded rods into the mounting holes on the bottom of the radome.
Up to 50 mm (2 in.) of the threaded rods may extend below the radome.
7 Apply a bead of marine sealant on the mounting surface around each mounting hole.
3
/
in.) mounting holes.
8
and the network cable to the network port
on the bottom of the case, and secure them using a cable
(Measuring and Setting the Front-of-Boat Offset,
3
/
in.), use longer threaded rods.
16
page 9).
3
/
to
16
.
7
Advertisement
Table of Contents
