Table of Contents
Advertisement
4 Preparation
Tips for saving energy
The following information will help you
to use your appliance in an ecological
way, and to save energy:
Use dark coloured or enamel
coated cookware in the oven since
the heat transmission will be better.
While cooking your dishes,
perform a preheating operation if it
is advised in the user manual or
cooking instructions.
Do not open the door of the oven
frequently during cooking.
Try to cook more then one dish in
the oven at the same time
whenever possible. You can cook
by placing two cooking vessels
onto the wire grill.
Cook more than one dish one after
another. The oven will already be
hot.
You can save energy by switching
off your oven a few minutes before
the end of the cooking time. Do
not open the oven door.
Defrost frozen dishes before
cooking them.
Use pots/pans with cover for
cooking. If there is no cover,
energy consumption may increase
4 times.
Select the burner which is suitable
for the bottom size of the pot to be
used. Always select the correct
pot size for your dishes. Larger
pots require more energy.
Pay attention to use flat bottom
pots when cooking with electric
hobs.
14 | EN
Pots with thick bottom will provide
a better heat conduction. You can
obtain energy savings up to 1/3.
Vessels and pots must be
compatible with the cooking zones.
Bottom of the vessels or pots must
not be smaller than the hotplate.
Keep the cooking zones and
bottom of the pots clean. Dirt will
decrease the heat conduction
between the cooking zone and
bottom of the pot.
For long cookings, turn off the
cooking zone 5 or 10 minutes
before the end of cooking time.
You can obtain energy savings up
to 20% by using the residual heat.
Initial operation
First cleaning of the appliance
The surface may get damaged by
N) —
some detergents or cleaning
materials.
Do not use aggressive
detergents, cleaning
powder/cream or any sharp
objects.
Remove all packaging materials.
. Wipe the surfaces of the appliance
with a damp cloth or sponge and
dry with a cloth.
Initial heating
Heat up the product for about 30
minutes and then switch it off. Thus,
any production residues or layers will
be burnt off and removed.
Advertisement
Table of Contents
