Table of Contents
Advertisement
e
Carry the product with at least two
persons.
Material damage!
The door and/or handle must not
be used for lifting or moving the
appliance.
e
Product must be placed directly on
the floor. It must not be placed
onto a base or a pedestal.
Electrical connection
Connect the product to a grounded
outlet/line protected by a fuse of
suitable capacity as stated in the
"Technical specifications" table. Have
the grounding installation made by a
qualified electrician while using the
product with or without a transformer.
Our company shall not be liable for any
damages that will arise due to using
the product without a grounding
installation in accordance with the
local regulations.
#s
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the appliance is only guaranteed
after correct installation.
Risk of electric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
The mains supply data must
correspond to the data specified on
the type label of the product. The
rating plate is either seen when the
door or the lower cover is opened or it
is located at the rear wall of the unit
depending on the unit type.
Power cable of your product must
comply with the values in "Technical
specifications" table.
&&
Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from
the mains supply.
Connecting the power cable
1. Amains cable is not supplied with
the product. The mains cable must
be connected by an authorised
person and be of the type men-
tioned in the Technical
specifications, page 5
This product must only be installed by
a qualified electrician eg local
electricity company or NICEIC
registered contractor to a suitable
double-pole control unit with a
minimum contact clearance of 3mm in
all poles and with a minimum rating
please consider technical data table,
Technical specifications, page 5 which
should be fitted adjacent to (but not
above) the cooker in accordance with
IEE regulations. Failure to observe this
instruction may result in operational
problems and invalidation of the
product warranty.
Additional protection by a
residual current circuit breaker
is recommended.
11 | EN
Advertisement
Table of Contents
