Accessories/Installation Procedure - Kenwood DDX1035 Instruction Manual

Accessories/Installation Procedure

Accessories
1 6
1
*
2 7
1
*
3
1
*
only.
2
*
(2m)
4
5
2
*
Installation Procedure
1
from the ignition and disconnect the ·
2
connections for each unit.
3
harness. (Accessory 2
4 Connect the wiring harness wires in the
(Accessory 1
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
34
English
7 Reconnect the ·
8
1
*
9 Perform the Initial Setup.
WARNING
(M5x6mm)
that in turn may start a fire. Always connect
1
*
those wires to the power source running
(M5x7mm)
wires via the fuse.
¤
professionals.
12V DC power supply.
humidity. Also avoid places with too much
the screws provided. If you use the wrong
screws, you could damage the unit.
position, connect the ignition wires to a
the ignition wire to a power source with
a constant voltage supply, such as with
are not touching to cause a short circuit,
then replace the old fuse with one with the
same rating.
circuit, do not remove the caps on the ends
of the unconnected wires or the terminals.