Kenwood TM-221A Service Manual page 36

M-221A/E/ES
ADJUSTMENT
Measurement Adjustment
Microprocessor operation check
[item | __ Condition Operation check
1, Reset 1) Turn the Power switch {Display 74, 5,001
ON holding the VFO/M _
and M.IN switches The! &1) indicator and the Mem-
down. ory channel number display tight
2) Release the VFO/M and for approx. 5 sec, after release
M.IN switches.
the switches,
1) Press the M.IN switch. — |/M- Tindicator lights.
[area |
2) Press the M.IN switch, |Display py ry} tif} Pos,
tion then press the REV
switch within 5 sec.
[item | ___— Condition Operation check
Simplex memory channels are; MO~9, MA, b.
Determine the desired FREQ., SHIFT, CTCSS, TONE FREQ.
then follow the procedure below.
1) Press the M.IN switch. The memory channel number
display lights.
2) Setect the desired
memory channel using
the Tuning control or
the Microphone UP/
DOWN switch.
This selection should be
completed within 5 sec.
after the M.IN switch is
Turn the Tuning control and
the UP/DOWN switches to in-
crease or decrease the figures as
shown below. (T,w) pressed.
20-25 <5 10-125 l 3) Press the M.IN switch Memory entry is completed.
15 CCW cw 15 within 5 sec. after the
1 223 memory channel selec-
125-10 5< 25+ 20 tion is completed.
(T,W)
fj}
3) Press any switch except [Receive FREQ. lights.
the LOW and the Power |(to return to the normal FREQ.)
switches to return to
1) Select the desired FREQ.
using the Tuning control
or the Microphone UP/
: DOWN switch.
the normal receive (as described in Item
FREQ. 4-1.)
. FREQ. 1) Press the MHz switch. The kHz digits goes off.
step 2) Turn the Tuning control {Rotating the Tuning control
selec- switch to*CW or CCW. switch changes the FREQ. in
tion 1MHz step.
(MHz) 3) Press any switch except |The kHz digits lights.
the LOW and the Power
switches to return to
the normal receive
FREQ.
38