Sharp FO-2600 Service Manual page 31

FO-2600TH/SG
FO-2600GU/GH
[4] ERROR CODE TABLE
1. Communication error code table
G3 Transmission
Final received signal Error Condition (Receiver side)
Incomplete signal frame |Cannot recognize bit stream after flag
NSF, DIS Cannot recognize DCS signal by echo etc.
L Cannot recognize NSS signal (FIF code etc)
CFR Disconnects {ine during reception (carrier missing etc)
FIT Disconnects line by fall back
MCF Disconnects line during reception of muiti page
Cannot recognize NSS, DCS signal in the case of mode change
PIP or PIN The line is hung up without replying to telephone request from the receiving party.
RTN or RTP Cannot recognize NSS, DCS signal after transmit RTN or RTP signal.
No signal or DCN No response in receiver side or DCN signal received" (transmitter side)
- Owing to error in some page the error could not be corrected although the specified number of
error retransmission was at tempted.
Error occurred after or while reception by the remote (receiving) machine was revealed to be
impossible.
Error occurred just after fallback,
Error occurred after a response to retransmission end command was received.
G3 Reception
Final received signal Error Condition (Receiver side)
Incomplete signal frame |Cannot recognize bit stream after flag
NSS, DCS _ |Cannot recognize CFR or FTT signal
Disconnects line during transmission (line error)
NSC, DTC Cannot recognize NSS signal (FIF code etc)
EOP Cannot recognize MCF, PIP, PIN, RTN, RTP signal
EOM Cannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
MPS The line is hung up without replying to communication request.
PR1-Q Cannot recognize PIP, PIN signal in the case of TALK request
No signal or DCN No response in transmitter (cannot recognize DIS signal) or DCN signal received" (receiver side)
- Error occurred upon completion of reception of all pages.
Olen | al Al alolr
- Error occurred when mode was changed or Transmission/Reception switching was performed.
= Error occurred during partial page or physical page reception.
lo
Error occurred after or during inquiry from the remote (transmitting) machine as to whether
reception is possible or not.
Error occurred during or just after fallback.
Error occurred after the retransmission end command was received.
ERROR CODE MESSAGE
* SUB CPU ERROR: I/F error and protocol error between main CPU and sub CPU
* HEATER ERROR : When the heater temperature is too high or too low or when the heater is turned off.