Table of Contents
Advertisement
Troubleshooting Guide
PROBLEM
POSSIBLE CAUSE
The power does not turn on.
The fuse has blown.
No sound can be heard, or the
volume Js low.
Attenuator is turned on.
SOLUTION
After checking for short circuits in the wires, replace the
fuse with one with the same rating.
Turn off Attenuator.
The fader or balance settings are set all the way to one
side.
Reset the fader or balance settings.
The input/output wires or wiring harness are connected
incorrectly.
Reconnect the input/output wires or the wiring harness
correctly. See the section on "Connecting Wires to Terminals"
Nothing happens when the
The computer chip in the unit is not functioning normaily.
buttons are pressed.
Press the reset button on the unit (see p. 6).
The sound quality is poor or
One of the speaker wires is being pinched by a screw in
distorted.
the car.
Check the speaker wiring.
The speakers are not wired correctly.
Radio reception is poor.
The car antenna is not extended.
Reconnect the speaker wires so that each output terminal is
connected to a different speaker.
Pull the antenna out all the way
The antenna control wire is not connected
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals'
The memory is erased when
the ignition is turned off.
The battery wire has not been connected to the proper
terminal.
A CD ejects as soon as it ts
The CD is upside-down
loaded.
esta
The CD ts quite dirty.
Connect the wire correctly, referring to the section on
'Connecting Wires to Terminals"
Load tte CD sath the labeled side up
Clean the CD. refecing to the section on "Cleaning CDs" (see
7}
The sound skips on a CD.
The CD is scratched or dirty.
Clean the CD, referring to the section on "Cleaning CDs" (see
y 7)
Turn off random play
rh
Advertisement
Table of Contents
