Touch Screen Surface; Touch Screen Protector - Beijer Electronics X2 control 12-B2 Installation Manual

Ajax / Vim in solution
Alkalicarbonate solution
1
Ammonia (<40%)
Acetic acid (<50%)
Ariel powder in solution
1
Bleach
Castor oil
1
Caustic soda (<40%)
Cutting oil
Cyclohexanol
Diacetone alcohol
1
Extremely faint glossing of the texture was noted.
The Autoflex protective film withstands DIN 42 115 Part 2 exposure of up to 1 hour duration to glacial
acetic acid without visible change.
The Autoflex protective film is not resistant to high pressure steam at over 100°C or the following
chemicals:
Concentrated mineral acids
Concentrated caustic solution

5.2.2. Touch Screen Surface

The touch screen surface on the HMI panel withstands exposure to the following solvents without
visible change:
Solvents
Acetone
Isopropanol
Toluene
The touch screen surface on the HMI panel is made of polyester with a hard coat to resist scratches
and withstand exposure to many solvents without visible change.

5.2.3. Touch Screen Protector

For harsh environments and exposure to outdoor conditions, it is recommended to use a protective
film to guard the touch screen from damage. This optional part can be ordered from Beijer
Electronics.
Beijer Electronics, MAEN223
1
Downy / Lenor
1
Ethanol
Glycerine
Glycol
1 1
Gumption
Hydrochloric acid (<36%)
Linseed oil
Methanol
Nitric acid (<10%)
Paraffin oil
Persil powder in solution
17
Phosphoric acid (<30%)
Potassium ferricyanide
Potassium hydroxide (<30%)
Pure Turpentine
1
SBP 60/95
Sulfuric acid (<10%)
Tomato ketchup
Trichloroacetic acid (<50%)
White Spirit
1
Windex
1
Wisk
Benzyl alcohol
Methylene chloride
Time
10 minutes
10 minutes
5 hours
Chemical Resistance
2023-09