Connecting For Power; Using Headphones; Demo Mode; Restore To Factory Settings - RCA RT2500 Getting Started

Connecting for Power
Make sure you connect all your other electronic components and the
speakers before plugging your receiver into the outlet. Plug the power cord
in the walt outlet, matching the wide blade of the plug with the wide slot
in the outlet. Besure to insert the plug completely.
Using Headphones
To listen privately through your audio system, use the PHONESjack on the
receiver. However, make sure you turn down the volume before you put on
the headphones. Increase the volume to the desired levelafter headphones
are in place.
Once headphones are connected, "HEADPHONE DOWNMIX 2
CHANNEL" will scroll on display.
iiii
Demo Mode
Right after you have plugged in the power, a demo message will appear in display. It wilt also be displayed if
you pressthe SET/DEMO at STANDBY mode. To restore to normal status, pressSET/DEMO again to return to
STANDBY mode.
Restore to Factory Settings
You can always restore all settings back to original state. When the receiver is in STANDBY mode, press accord-
ingly as:
STADIUM _ NIGHT _ DSPOFF _ CLUB
then you can restore everything like preset radio station frequencies, speaker settings,etc, back to the first
time you use it.
Note: As you turn on the receiver, it will first enter TUNER mode and show frequency as 87.5MHz after the
settings have been restored.
• - ................................................................................................................................................................................ °-o"
Z