Connecting The Antennas; Connecting The Speakers; Connecting The Subwoofers - RCA RT2500 Getting Started

Hide thumbs Also See for RT2500:
Table of Contents

Advertisement

iiiiiiiii
iiiiiiiii
iiiiiiiii
iiiiiiiii
iiiiiiiii
i
Red/Black (Main Speakers), Blue/Black (Center
i
Ctia_onnec__n
o the Antennas
Speaker) and Grey/Black (Rear Speakers).When con-
The AM and FM antennas connect to the AM and
necting the speakers, make sure the colors of speak-
FM terminals on the system's back panel. They must
er wires and terminals are matched. If the cords are
be hooked up in order to receive clear reception,
reversed, the sound will be distorted and will lack
i
Uncoil the antenna wires and locate the bare ends.
bass.
::
Pressdown on the tab to open the terminal and
insert the wire. Snap the tab closed. After connect-
CENTER
__
;_j
ing the antennas, extend
SPEAKER
MAIN S PEAKERS
Antenna and
Speaker
them to their full length
Wire Connection
and adjust their positioning
for better reception.
Connecting the
Push Speaker
t ......
, tab
Speakers
down
to
qser[
wire
At least two front speakers
(left and right) are required.
For better sound quality,
Center speaker, rear speak-
ers and Subwoofer are pre-
Release
tab
to
lock wire
in
theterminal
ferred. Adding center and
_
Use t hBjackon
the left b ack
NOTE: Make sure theinsulation
rear speakers wilt enhance
L_ j oaoe_
fo, _ n,,eot,no
oowered
is comple[el_
removed
trom the
sub woofer
ends of the Antenna
anc
surround effects. Adding a
SURROUND SOUND SPFAKERS
speaKer wires at alI connection
points
Subwoofer will increase
_
,_
bassresponse,
i
If you want to enjoy full range of sound effects, with
small speakers, it is a must to use the subwoofer
For RT2500.connect the subwoofer with the audio
:
with the speakers to maintain adequate bass signal
cord (brown/black) provided. For RT2500R,or if you
:
for the surround sound effect,
want to connect your own powered subwoofer, a
monoaural audio core (not supplied) is needed.
Speaker cords, 1 for each speaker, are needed for
i
connection. Twist the stripped ends of speaker cord
This receiver offers a high flexibility for user to use a
.
about 2/3 inch (15 mm). Pressdown on the tab to
large variety of speakers and subwoofers. For more
open the terminal and insert the wire. Snap the tab
nformation please refer to section "Fine Setting of
closed. To ease speaker connections, the speaker
the Speakers" in "Advanced Sound Control" on
cords and the terminals are color-coded into:
page 12.
oo................................................................................................................................................................................
,oO°
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rt2500r

Table of Contents