Hitachi SJ Series Operation Manual page 8

ATTACHING THE AIR PURIFYING FILTERS
CAUTION
!
Before cleaning, stop operation and switch off the power supply.
1
O pen the front panel
Pull up the front panel by holding it at both sides with
●
both hands.
2
Remove the Pre-fi lter
Push upward to release the clasps and pull out the
●
Pre-fi lter.
3
Attaching the air purifying fi lters
Attach the air purifying fi lters to the C-case by gently
●
compress its both sides and release after insertion
into fi lter frame.
Bring the C-case to the back side of the pre-fi lter.
●
Insert it claws on left and right to the C-case fi xing
slot securely. Honeycomb surface shall be on the front
side and fl at surface shall be on the back side when
insert (only for the purifying fi lter with a fl at surface).
! CAUTION
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
4
Attach the Pre-fi lters
Attach the Pre-fi lters by ensuring that the surface written
●
"FRONT" is facing front.
After attaching the Pre-fi lters, push the front panel at
●
three arrow portions as shown in fi gure and close it.
NOTE
In case of removing the air purifying fi lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
●
fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
Air purifying fi lters are not washable. It is recommended to use vacuum to clean it. It can be use for 1
●
year time. Type number for this air purifying fi lter is <SPX-CFH22PM25>. Please use this number for
ordering when you want to renew it. Part can be purchased from an authorized service parts centers.
C-case fi xing slot
Flat surface (Back side)
Honeycomb surface (Front side)
– 8 –
Pre-fi lter
Air purifying fi lter
C-case
Claw