Sony HANDYCAM DCR-HC30 Operation Manual page 113

_i_)_!!!ii!!il ¸ I::I!_ ¸i¸!_!;I!I ¸¸I ¸::II: ¸:il ¸I ¸:I ¸i:il;_i! ¸I!I ¸i:i:;iil;i!ii:i:;iil;i!ii:i:;iil;i!ii:i:;iil;i!ii:i:iiiii_i_!i_ ¸_i_:_ii_!!!_i_i_iiii!_i:!i ¸i::!_¸¸iii¸¸:! ¸:ii:_ii:!i_:i:; ¸II ¸;!_I ¸;_i:i:;_ii:i ¸i:i ¸;_i!;!!i ¸i:i:;iil;!!ii:i:;iil;!!ii:i:;iil
The CItG (charge) lamp does not -)Attach the battery pack to the cmncorder correctly. I fthe Imnp still does
light while the b_ltery pack is being nol light up, then it indic_les the1 no power is supplied from the wall
charged, oullet.
• The b_ltery charge is completed. (p. 16)
The CIIG (charge) lamp flashes while -)Attach _he battery pack to tbe eameorder correctly. If the problem
the battery pack is being charged, persists, disconnect the AC Adaptor from the wall outlet and contacl
your Sony dealer. The ballery pack may be damaged. (p. 16)
The battery pack is quickly • The temperature of 1he environment is too low, or the battery pack has
discharged, nol been charged enough. This is not a mal|hnotion.
-)Fully charge €he batlery again. If the problem persists, replace the
battery pack with a new one. It may be damaged. (p. 16, 129)
The remaining battery time indicator • The temperature of the environment is too high or too low, or the batter
does not indic_le the correct time. pack has not been charged enough. This is nol a malfunction.
-)Fully charge €he batlery again. If the problem persists, replace the
battery pack with a new one. It may be damaged. (p. 16, 129)
The power turns off frequenlly • A problem has occurred in the remaining ballery time indicator, or the
although the remaining battery battery pack has not been charged enough.
indicator indicales that the battery -)Fully charge the battery again to correct the indication. (p. 16)
_ack has enough power to operale.
The power abmplly turns off.. • [A.SHI.JT OFF] in the _ (STANDARD SET) menu is set to [5 rain].
(p. g7)
-)When approximately 5 minu_es have elapsed while you do no_ operate
your camcorder, the camcorder is automatically turned off.
Slide _he POWER switch down to turn the power on _g_in. (p. 19) Or
use the AC Adaptor.
A problem occurs when the -)Turn offthe power, and disconnect the AC Adaptor from the wall outlet.
camcorder is connected to the AC Then, connect it again.
Adaptor.
Cassette cannot be ejected from 1he -)Make sure the power source (baltery pack or AC Adaptor) is connected
compartment, correctly. (p. 16)
-)Remove the battery pack from the camcorder, then altach it again. (p. 16)
-)Attach a charged batlery pack to the camcorder. (p. 16)
Cassette is nol ejected even when the • Moislure condensalion is starting in your camcorder. (p. 132)
casselle lid is open.
-_continued
Troubleshooting 113