Table of Contents
Advertisement
DUBBING
B-DECK
EJECT
e
Synchro dubbing
@ Press the POWER switch to set to ON ( = ).
@ Insert a prerecorded tape into deck A with
side A facing out and press the <I> (direc-
tion) button to select the travel direction.
@ Insert the blank tape with side A facing out
into deck
B, and press the I> (direction)
button to select the side to be recorded. -
@ Press to "0000".
@ Press the SYNCHRO
DUBBING (NORM
or HIGH SPEED) button to start dubbing.
@ Press the Ml (stop) button of deck B to
stop dubbing.
When
deck
B stops, the dubbing
mode
is.
automatically released.
e
Synchro record muting
When deck A stops or enters any mode
other than the playback mode during dub-
bing, deck B enters the record mute oper-
ation automatically
and then enters the
record-pause mode.
«
Before pressing the SYNCHRO DUB-
BING button
Confitm that*deck B is in the stop mode
before starting dubbing.
Dubbing and DOLBY NR switch
During dubbing, the same NR mode selected
for the playback cassette
is applied to the
recording cassette, regardless of the position
of the NR switch.
Input level
Recording is performed at the same level as
the playback tape during dubbing regardless
of the position of the INPUT LEVEL control.
rT
a rc ~ [~~ —_
~
a
APBSYNCHRO DUBBING
HIGH SREED
.
pre editing
. Press
the
©
REC/REC
MUTE
button
when finished dubbing a tune.
Deck
B automatically enters the record
muting mode and leaves a non-recorded
section of about 4 seconds then enters
the record-pause mode.
2. Press the I (stop) button of deck
A and
search
for the next tune
you want
by
using the >> , ««, or PLAY button. Then
stop the cassette just before the begin-
ning of the tune.
3. Press the same SYNCHRO DUBBING but-
ton pressed before ihe: pause again, and
dubbing will start.
:
Notes at dubbing
1. Normal-speed dubbing is recommended
to obtain good sound quality.
2. Television receivers placed close to the
deck
may
cause
interference
on
the
recorded signal when the deck is used in
the high-speed dubbing mode. If this hap-
pens, either turn off the television receiver
or use the normal-speed dubbing mode.
@
e
POWER
-
TANDBY
cle
3
5
wt
e0
(No. 4325) 11
Advertisement
Table of Contents
