Advertisement
2 Clean skin by washing your face so that makeup and dirt will wash off.
Wipe off makeup with a cleansing product.
3 Attach cotton to the body of the device. (Fig.2)
The narrower side should be upward.
(1)Remove the protection seal from the heating head.
●
Unless the protection seal is removed, the device will not operate.
(2)Place cotton over the head and attach it with the included ring.
●
Use commercially available cotton. However, small cotton or thick cotton may not
work in some cases.
●
The ring has an orientation with a clear direction. Attach it from straight above with the
wider part of the inner circumference placed toward the heating head.
Do not attach the ring in the reverse direction. Please be careful not to squeeze it,
otherwise, it cannot be removed.
4 How to remove the ring. (Fig.3)
Remove the ring by pulling it straight up while holding down the lower part.
5 Please observe the following so as not to damage your skin when you use the device.
(1) The maximum amount of time allowed for skin care with use of this device is 8
minutes per day in basic mode. (Limit use of step 1,2,3 to no more than 3 minutes
per day. Limit use of step 4 to no more than once a day.)
Basic mode
(HOT CLEANSING)
Automatic shutoff
Step 1
approximate 3 minutes
(HOT MOISTURIZE)
Step 2
approximate 3 minutes
Step 3
Step 4
(Preparation for cooling ： approximate 10 seconds)
(Time for use: approximate 1 minute and 50 seconds)
●
Limit use of the device to no more than 11 minutes per day including use of
"HOT MASK."
It is recommended that you use "HOT MASK" once a day for milky lotion or once
●
or twice a week for sheet mask.
(2) Use the device on bare skin after removing makeup.
(3) Do not use the device on the same area of skin for more than 10 seconds.
(4) Switch between high and low by pressing the level switch button according to the
condition of your skin.
●
You can choose high, medium and low as you like.
If your skin tingles, use the device on "Low."
●
If you feel something unusual with your skin, stop using the device and consult a
skin care specialist.
Cotton
Automatic shutoff
（HOT MASK）
Automatic shutoff
approximate 3 minutes
（COOL）
Automatic shutoff
-5-
Example for use
Press the mode switch button and set the mode of your preferred treatment.
Quick tighten-up treatment (Required time: approximate 2 minutes)
●
Step 4 "COOL"
When you want to tighten your pores or cool down your skin before applying make up,
you can just use "COOL." After 10-second preparation for cooling, it only takes
approximate one minute and 50 seconds to tighten the pores of your skin. Press the
mode switch button to set to "COOL."
Quick treatment (Required time: approximate 3 minutes)
●
Step 2 "HOT MOISTURIZE"
When you do not have much time in the morning or when you need to go out suddenly,
you can just use "HOT MOISTURIZE." It only takes approximate three minutes to
moisturize your skin thoroughly. Press the mode switch button to set to
"HOT MOISTURIZE."
Tighten-up treatment (Required time: approximate 5 minutes)
●
Step 1 "HOT CLEANSING"
●
Step 4 "COOL"
When you want to remove fine residue remaining in pores and tighten the pores of your
skin, use "COOL" after using "HOT CLEANSING." This treatment cleanses and
tightens the pores of your skin. After the "HOT CLEANSING" mode is finished, press
the mode switch button to set to "COOL."
Moisturize treatment (Required time: approximate 6 minutes)
●
Step 1 "HOT CLEANSING"
●
Step 2 "HOT MOISTURIZE"
Before you go out or when you have more time, use "HOT MOISTURIZE" after using
"HOT CLEANSING." This treatment moisturizes the clean skin thoroughly.
Daily treatment (Basic mode) (Required time: approximate 8 minutes)
●
Step 1 "HOT CLEANSING"
●
Step 2 "HOT MOISTURIZE"
●
Step 4 "COOL"
Standard daily moisturize treatment
After using "HOT CLEANSING," moisturize the clean skin in "HOT MOISTURIZE and
tighten the pores of your skin by cooling effect in "COOL." After the "HOT MOISTURIZE"
mode is finished, press the mode switch button to set to "COOL."
Recommended full treatment (Required time: approximate 11 minutes)
●
Step 1 "HOT CLEANSING"
●
Step 2 "HOT MOISTURIZE"
●
Step 3 "HOT MASK"
●
Step 4 "COOL"
Care for your skin once or twice a week by using all modes.
Fine vibrations in "HOT MASK" mode and gentle switching of the electrode will enhance
the moisturizing effect of lotion or mask. The cooling effect of "COOL" mode will tighten
the pores of your skin.
How to use
●
Make sure to use only 100-240V AC for power supply and use the included power
adaptor (this device is not rechargeable).
●
After the power switch is switched to "On," the heating head warms slowly.
-6-
Advertisement
