Advertisement
This mark means that this appliance shall not be used near water contained
in bath-tubs, basins or other vessels.
Do not wash or splash water on this product.
(Cause of failure or short circuit)
Use prohibited
in wet areas
Do not use or keep this product in places easily splashed with water or in
damp places, such as in a bathroom. (Cause of failure or short circuit)
Do not alter disassemble or repair by unauthorized techinician.
(Cause of fire, electric shock, injury, or failure)
Disassembly
prohibited
Check the head for any damage or deformation before use.
(Cause of damage to skin)
Do not use this product together with other beauty treatment devices at the
same time. (Cause of failure or trouble)
Do not use this product if there is some injury or wound to your skin.
(Cause of skin trouble or pain)
Do not drop this product or give it a strong impact.
(Cause of injury or failure)
Prohibited
Do not leave this product in a place where the temperature becomes high
such as the inside of a vehicle. (Cause of failure)
Do not wipe with benzene, thinner or alcohol, and do not spray insecticide.
(Cause of cracking, electric shock, or ignition)
Use only the original power adaptor. And, do not use any other product
with the original power adaptor. (Possibility of electric shock or ignition)
Remove accessories such as earrings and necklaces, and contact lenses
before use. (Cause of accident or trouble)
If there is any severe skin disorder or irregularity on your skin surface, or due
to downy hair, you may feel strong irritation in rare instances. In this case,
avoid using this product on that region. (Cause of accident or trouble)
Do not keep the cotton puff or the head on one part of your skin but always
Make sure
keep it in motion. (Cause of skin trouble or poor physical condition)
Do not hold the cord to pull out the power plug and device plug.
(Cause of disconnection, electric shock, short circuit, or ignition)
When there are people around the device, pay attention to any sudden
movement during use. (Cause of injury)
Make sure to pull out the power plug from the outlet while not in use.
(Cause of electric shock or fire by deterioration)
Unplug
-3-
Names of parts and their functions (Fig. 1)
Heating head (titanium material)
Attach cotton and apply it to your skin.
The device vibrates while being used in
modes other than "Cool."
Mode indicator lamp
During use
Mode
During preparation
Orange lamp
Orange lamp
HOT CLEANSING
flashing
lights
HOT MOISTURIZE
HOT MASK
Blue lamp flashing
Blue lamp lights
COOL
Mode switch button
Every time the button is pressed, the
mode for use will be switched.
("HOT CLEANSING" is initially set.)
Power switch (" ")
Turn on the power switch, and it will turn
"On." Press it again, and it will turn "Off."
An automatic shutoff function is equipped,
so if the device is not used for around 3
minutes, it will automatically turn "Off."
Body socket
Body
Level indicator lamp
LOW (green): MEDIUM (green): HIGH (red)
When the power switch is switched to "On,"
the lamp indicating "Low" is turned on. This
lamp is not turned on in "Cool" mode.
Level switch button
Every time the button is pressed, "the
strength" of the electrical potential will
change. There will be no change in
vibration strength. ("Low" is initially set.)
Preparation before use
Never use the device when you have a wound or an inflammation on
your skin. (Cause of problems with or damage to your skin.)
Remove jewelry or contact lenses.
(Cause of problems with your skin or physical discomfort.)
1. About mode switching
Mode
HOT CLEANSING (cleans fine residue
Use new cotton saturated with your regular
remaining in pores)
toner.
HOT MOISTURIZE (performs
Use new cotton saturated with your regular toner.
moisturizing care by allowing moisturizing
If you use a gel-like or thick toner, you can also
ingredients to penetrate into skin)
apply it to heating head without using cotton.
HOT MASK (enhances the effect of
Use your regular milky lotion or a sheet mask by
applying to skin. Do not use cotton.
milky lotion or sheet mask)
COOL (tightens the pores of your skin
Apply the cooling head directly to your skin.
by cooling effect)
Do not use cotton and toner.
Buzzer (Switching sound/ready
sound/warning sound/finish sound/
indicating timer sound)
Every time the switch or button is
pressed, the switching sound will beep.
When the preparation is completed in
"Cool" mode, the ready sound will beep.
The warning sound will beep to indicate
the continuous use of "Cool" mode.
In the event of a failure, an abnormality
detection sound will beep. When each
mode is finished, the finish sound will
beep.
Cooling head (aluminum material)
Apply this head to your skin in "Cool"
mode.
Back plate (titanium material)
Touch this part and apply the heating
head to your skin in modes other than
"Cool," and the device will start to
operate.
Power adaptor
Model: KH-186B
Power plug
Instrument plug
Cord
Accessories
Rings (two) : Rings for attaching cotton.
Stand
Materials needed
-4-
Advertisement
