Table of Contents
Advertisement
tNOTESE
+ SME Playback
'The built-in disk drive of the piano allows playback of SMF (stan-
dard MID
files) from diskette. See "Lsing the Floppy Disk Drive"
'on page E-63 for details.
To select the Mixer mode
E-40
internal Mode
'on and off.
and Song Sequencer playback.
£xternal Mode
On/otf settings in this mode alfect MIDI input and SMF playback
channels.
3. Use the [4] and [pb] CURSOR keys to select the
channel whose parameters you want to change.
= See page E 39 for details on layer, split, Auto Accompani-
ment, and Song Sequencer channel assignments.
* The frame around the currently selected channel (the cur-
rent channel) flashes. to indicate that it is selected.
ybitie
[=—— Cnannei rumver frame
TTTTEN
« The on/cff status of the current channel is indicated in the
measure number area of the display (item 12 on page E-14).
4. Change the current channel's tone and volume pa
rameters while a channel number frame is flashing, if
you want.
* Use the [+] and [-] buttons to change the tone.
* Use [4] and '¥] to change the volume. The current volume
setting is shown as a value in the metrorome area of the dis
play (iter 6 on page E-14).
-On
VOLUME
mn
uu
To make additional settings for the current cnannel,
press the ENTER button while a channel number frame
is flashing.
+ See "To make additional channel parameter settings" for
details
on making additional channel parameters
6. After making additiona' settings in step 5, press the
ENTER button.
* If you do not perform any operation for about seven sec-
'onds while a channel number frame is flashing, the display
returns to that in step 2 of the above procedure autamatical-
ly.
INOTES #
* Internal Mode and External Mode settings you make with thi
procedure are stoved separately
+ Youcan change the parameters of @ channel regardiess of whether the
cchannat is on or off
* Changing a Mixar internal mode channel setting causes tne MIDI mas-
'sage that corresponcs to the change to be output through the MiD! OUT
terminal.
ove
To make additional channel parameter settings
Use the [4] and [¥] CURSOR keys to scroll through the setting screens
shown below.
While any sethng screen is on the display, use the [+] and (-] buttons
zo change che parameter to the value you want.
{Pare
a
'Screen
[Batting Range:
Program Change Number [GOOF r99,No
000-23
295 Volume
60 ~ 127
BGY4Pan
900 ~ 127
OYGEt fect
90 ~ 127
OGFineTune | ~s0-w- s9
a0C.Tune
| -v-w-2
See the following section titled "Additional Channel Mode Parame
ters" on page E-4? for details on what each of these parameters con-
trols
ENOTES E
+ The tir screen is normally the pan screan. If you usad the additional
channel
parametar scraane since turning an powar, the last
satling you
rs first.
the {-¢} and {| CURSOR keys to change tho curront chan
nel while an additional channel parametar screen is on the display.
+ Channel 10 is reserved for drum sounds, 80 only lone number 192 to
199 can be selected.
E-41
Advertisement
Table of Contents
