Cleaning And Maintenance; Troubleshooting - TaoTronics SoundLiberty 80 User Manual

Successfully paired
/
with your device
Bluetooth out of
/
Range / Failed to
pair with your device
Note: The Multifunction Touch Control is available only when you are
wearing the earbuds.

CLEANING AND MAINTENANCE

1. Clean the earbuds and the charging case on a regular basis.
2. Use dry and soft cotton cloth to wipe the unit.
Note: Do not insert anything into the product.
3. Keep away from sharp objects to avoid scratches.
4. Put the unit in a dry and shady place if it is to be idle for a long time.
5. Do not clean the product with detergent or chemicals.

TROUBLESHOOTING

No. Problem Solution
Failed to turn on the
Earbuds low battery, please charge them
1
earbuds
• Place the earbuds into the charging
Failed to charge the
2
case properly
earbuds
• Make sure the charging case is charged fully
Can't charge the Make sure the charging cable is intact
3
charging case and plugged in properly
09
Connected
Disconnected
The earbuds reconnected with previously
paired device automatically:
Can't find
• Deactivate the Bluetooth function of
"TAOTRONICS
previously paired device or clear
SoundLiberty 80" in
4
"TAOTRONICS SoundLiberty 80" from
the Bluetooth
its Bluetooth device list, and then
device list
search again
• Put the device to be connected close to
the earbuds
• Turn on the device and activate its
Failed to pair the
Bluetooth function before pairing
5
earbuds with your
• Bring the earbuds into pairing mode
device
as instructed in the "Pairing" section
• As instructed in Single Earbud Mode,
make sure both earbuds are paired with
your device first.
Failed to use a
6
• Then follow the steps to pair the single
single earbud
(left or right) earbud with your device.
• Once paired, you can freely use the
single (left or right) earbud.
Place both earbuds back to the charging
case then take them out, they will pair
No sound in one of
with each other automatically. If pairing
the earbuds in
7
failed, restore them back to the factory
couple earbuds mode
settings as instructed in the "Clear Pairing
List" section
10