Advertisement
Please read the instructions thoroughly before using this product and retain it for future reference.
Hearing Safety
This product contains lithium battery. Never expose it to excessive heat such as direct sunlight or fire to avoid explosion.
Please wear the earbuds as shown below.
Pictures only for reference.
Note:
Uncover the lid and they will power on automatically.
Put the earbuds into the charging case and close the lid, they will turn off automatically.
Note:
If you failed to pair your device with the earbuds, please clear the pairing history as instructed below:
Function | Operation | Voice Prompt |
Play / Pause | Tap the Touch Control on either of the earbuds twice under music | / |
Volume + | Tap the Touch Control on the right earbud | Toots when highest setting is reached |
Volume - | Tap the Touch Control on the left earbud | / |
Next Track | Tap the Touch Control on the right earbud three times | / |
Previous Track | Tap the Touch Control on the left earbud three times | / |
Answer Phone Call | Tap the Touch Control on either of the earbuds once | / |
Hang up Phone Call | Tap and hold the Touch Control on either of the earbuds for 2 seconds | / |
Decline an Incoming Call | Tap and hold the Touch Control on either of the earbuds for 2 seconds | Call rejected |
Turn On / Off Voice Control | When paired successfully, tap and hold the Touch Control on either of the earbuds for 2 seconds until a beep is heard | Toot |
Clear Pairing List | Refer to the "Clear Pairing List" section | / |
Go into Pairing Mode | Refer to the "Pairing" section | Pairing |
Successfully paired with your device | / | Connected |
Bluetooth out of Range / Failed to pair with your device | / | Disconnected |
Note: Only when you are wearing the earbuds can you hear the voice prompt.
No. | Problem | Solution |
1 | Failed to turn on the earbuds | Earbuds low battery, please charge them |
2 | Failed to charge the earbuds | • Place the earbuds into the charging case properly • Make sure the charging case is charged fully |
3 | Can't charge the charging case | Make sure the charging cable is intact and plugged in properly |
4 | Can't find "TAOTRONICS SoundLiberty 92" in the Bluetooth device list | The earbuds reconnected with previously paired device automatically: • Deactivate the Bluetooth function of previously paired device or clear "TAOTRONICS SoundLiberty 92" from its Bluetooth device list, and then search again • Put the device to be connected close to the earbuds |
5 | Failed to pair the earbuds with your device | • Turn on the device and activate its Bluetooth function before pairing • Bring the earbuds into pairing mode as instructed in the "Pairing" section |
6 | No sound in one of the earbuds in couple earbuds mode | Place both earbuds back to the charging case then take them out, they will pair with each other automatically. If pairing failed, restore them back to the factory settings as instructed in the "Clear Pairing List" section |
7 | Poor sound quality | • Wear the earbuds properly and keep them close to each other. • Place the connected device close to the earbuds or remove the obstacles between them • Clear the debris on the earbuds |
8 | Unstable connection | • Keep the earbuds close to your Bluetooth device • The effective distance may shorten with obstacles in the way • Turn off other Bluetooth devices to decrease the interference |
9 | Can't hear the other party during a phone call | Set the volume to higher level |
10 | The other party can't hear your voice during a phone call | Free the built-in microphone of any covers |
11 | Multifunction Touch control of the earbuds is unresponsive | Place the two earbuds into the charging case and cover the lid, disconnect the Bluetooth connection. Uncover the lid to turn on the earbuds and pair again. |
If any problems occur, please contact the TaoTronics Customer Care Centre in your country via the contact information listed in this User Guide.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Sunvalleytek International Inc. is under license. Other trademarks and trade names are those of their respective owners.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Correct Disposal of This Product (Waste Electrical & Electronic Equipment) (Applicable in countries with separate collection systems) This marking on the product, accessories or literature indicates that the product and its electronic accessories should not be disposed of with other household waste at the end of their working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate these items from other types of waste and recycle them responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take these items for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product and its electronic accessories should not be mixed with other commercial wastes for disposal.
ASIA PACIFIC
E-mail: support.jp@taotronics.com(JP)
EUROPE
E-mail:
support.uk@taotronics.com(UK)
support.de@taotronics.com(DE)
support.fr@taotronics.com(FR)
support.es@taotronics.com(ES)
support.it@taotronics.com(IT)
NORTH AMERICA
E-mail:
support@taotronics.com(US)
support.ca@taotronics.com(CA)
Tel: 1-888-456-8468 (Monday-Friday: 9:00 – 17:00 PST)
MANUFACTURER
Manufacturer: Shenzhen NearbyExpress Technology Development Co.,Ltd.
Address: Floor 7, Building E, Galaxy World Phase II, Shenzhen, China
Learn more about the EU Declaration of Conformity:
https://www.taotronics.com/pages/user-manual
MADE IN CHINA
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the SoundLiberty 92 and is the answer not in the manual?
Questions and answers