Toro 147-0090 Installation page 3

3
Installing the Deck
Channels
Parts needed for this procedure:
4 Hex-head flange bolt
4 Flange nut
2 Deck channel
2 Hex-head bolt
2 Washer
Procedure
Perform these steps for both lift arms.
1. Slide the deck channel over the deck tube
(Figure 3) and use a clamp to secure the deck
channel to the deck tube.
1. Deck channel
2. Lower the lift arm so that the lift-arm hub is
positioned in the deck channel.
3. Loosely assemble the hex-head bolt and washer
to ensure that the saddle and hub are centered
(Figure 4).
Important:
Ensure that the "cup" of the
washer is toward the lift arm. Do not tighten
or torque the bolt.
Figure 3
1. Existing large bolt
4. Mark the 2 bolt-hole locations in the deck tube
and use an drill bit (11/32 inch) to drill through
the marked deck-tube holes. Drill through bolt
sides of the tube
WARNING
Using a drill without proper eye
protection may allow debris to enter the
eye, causing injury.
When drilling, always wear eye
protection.
Important:
aligned so that you drill only through the
deck tube.
g444223
1. Drill holes in the deck tube.
5. Use the hex-head flange bolts and flange nuts
to secure the deck channel to the deck tube
(Figure 6).
3
Figure 4
2. Washer
(Figure 5).
Ensure that the drill is properly
Figure 5
g444224
g444225