Page 1
Form No. 3463-130 Rev A Trimmer Rack GrandStand ® Revolution ® Mower Model No. 145-3530 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine for installation.
Page 2
Preparing the Machine No Parts Required Procedure Park the machine on a level surface. Disengage the drives and the power take-off. Shut off the machine and remove the key. Wait for all moving parts to stop. g377627 Turn the battery-disconnect switch to the O Figure 2 position.
Page 3
WARNING Using a drill without proper eye protection may allow debris to enter the eye, causing injury. Installing the Upper Bracket When drilling, always wear eye Assembly protection. Use a drill bit (9/32 inch) to drill through the 3 Parts needed for this procedure: marked hole locations.
Page 4
Installing the Lower Mount Bracket Parts needed for this procedure: Lower mount bracket Screw (5/16 inch) Adjustment plate Carriage bolt (1/4 x 3/4 inch) Nut (1/4 inch) g441543 Small fist clamp Figure 5 Small backer plate 1. Slot bracket 3. Nut (1/4 inch) Hex-head flange screw (1/4 x 1-1/2 inches) 2.
Page 5
Use 2 hex-head flange screws (1/4 x 1-1/2 WARNING inches) and 2 nuts (1/4 inch) to secure the Using a drill without proper eye small backer plate and small fist clamp to the protection may allow debris to enter the adjustment plate.
Page 6
Note: Position the upper trimmer handle so that is held in place by the upper clamp. Completing the Installation No Parts Required Procedure Install the rear access cover. g442743 Figure 13 g377627 Figure 11 Raise the cushion to the platform. Tighten the twist knobs on each side of the machine.
Need help?
Do you have a question about the 145-3530 and is the answer not in the manual?
Questions and answers