Satco NUVO 67-120 Installation And Safety Instructions

LED EXIT SIGNS
EXIT AND EMERGENCY LIGHT COMBO
BATTERY BACKUP
Models: 67-120, 67-121, 67-122, 67-125
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or any
maintenance of the fixture.
• To avoid damage, falling, electric shock or fire, do not
modify the fixture or replace accessories.
• Only authorized, qualified personnel should install this
fixture and should follow the owner's manual.
• Do not dismantle the fixture.
• Do not touch the power supply when the fixture is
operating.
• For use in environments where an accumulation of
non-conductive dust on the fixture may be expected.
• Damp rated. Do not use outdoors.
• Do not mount near gas or electric heaters.
• Do not let power cords touch hot surfaces.
• Use caution when servicing batteries. Avoid possible
shorting.
• Equipment should be mounted in locations and at heights
where it will not readily be subjected to tampering by
unauthorized personnel.
• The use of accessory equipment is not recommended
and may cause an unsafe condition.
• Do not use this equipment for other than intended use.
• Disconnect AC Power and unplug battery before
servicing.
• Battery in this unit may not be fully charged. After the
AC service is supplied to unit, let the battery charge up
for at least 24 hours before performing any tests.
IMPORTANT: This product must be installed in accordance
with the applicable installation code by a person familiar
with the construction and operation of the product and the
hazards involved.
MAXIMUM MOUNTING HEIGHT: 117ft (5.18m)
MAINTENANCE: Battery may need to recharge upon
initial power up. We recommend that the equipment be
tested regularly in accordance with local codes. Replace
the batteries as needed if discharge time does not achieve
90 minutes.
OPERATION: Press the test button, unit luminance by
battery backup and the LED indicator will turn off, release
the test switch, LED indicator will turn on.
ROUTINE TESTING: National Electric Code (NEC) and
NFPA life safety code regulations require that routine tests
need to be performed as stated:
• Once every month, perform 30 second duration test.
Push in and hold the test switch to perform this test.
• Once every 12 months, perform full 90 minute test.
Disconnect AC power supply and transfer to emergency
mode. The unit should stay on 90 minutes minimum.
© Copyright 2023 Satco Products, Inc. 3/23 v1.3
67-120: Green
67-121: Red
67-122: Red / Remote Compatible
67-125: Green / Remote Compatible
Use Flexible Conduit Only
WIRING DIAGRAM
• Connect the white wire to neutral.
• If using 120VAC, connect the black wire to the
hot lead.
• If using 277VAC, connect the orange wire to
the hot lead.
• Cap off unused wires. In all cases, use standard
wire nuts to connect to wires.
Orange 277VAC
White NEUTRAL
Black 120VAC
TROUBLE SHOOTING GUIDE: If LED indicator
does not illuminate, check the following:
1. Check AC supply – verify that unit has 24 hours
AC supply.
2. Unit is shorted or battery is not connected.
3. Battery discharged. Permit unit to charge for
24 hours then re-test.
1
Lamp Lamp
Head Head
PC Board
Remote
Connector
Battery
Battery
Remote
(option)
Head
Satco Products, Inc.
Brentwood, NY 11717