Advertisement
|
ON
BBR
EU
UBB
BRR
RRM
ee
ee
Finally plug the accessory power cord to the AC
IN jack and a household power outlet (which
should permanently be supplied with power.)
turned off.
Nese
eee
USING
TELEVISION
WITHOUT
AUDIO
AND
VIDEO JACKS
VHF
television
antenna
UHF
television
antenna
Optional
RF modulator
1. Detach the VHF antenna cable from the VHF antenna
terminal of your TV set, and connect the cable to the
VHF IN terrrinal of the RF modulator.
2. Connect the VHF OUT terminal of the RF modulator to
the VHF antenna terminal of your TV set.
3. Connect the socket (3-pin) of the RF modulator to the
VHF ADAPTER jacks.
NOTE:
Push the plug in firmly. If the plug is not properly inserted,
it may result in snow or noise on the screen.
When the sound from a LaserDisc or Compact Disc is
Output through a telev sion speaker it becomes monaural
sound (This is the same for a stereo television).
NOTES:
@
Stripe patterns may appear when a LaserDisc is played
ona television. Move the antenna cable away from the
power cord to avoid this.
@
Be sure to turn off the power of this player when you
watch a TV broadcast.
(pLuG THE POWER
CORDS INTO AN AC OUTLET
Plug the AC power cords of the player, stereo amplifier and TV set into an AC outlet.
When the power cord of this unit is connected to an AC outlet, power is supplied to the
unit's internal memory (such as the last memory) even when the POWER
switch is off
(STANDBY).
Therefore, be sure to connect the power cord directly to a wall outlet.
If
the power cord is connected to an outlet such as a switched outlet on an amplifier, the
various memory
contents
will be erased whenever
the amplifier's power
switch
is
J
secrete /
CONNECTING TV AND STEREO AMPLIFIER
e Connect the VIDEO OUT jack of the player to the video
input jack of the monitor television.
e@ Connect the AUDIO OUT jacks to the stereo amplifier
AUX, CD, LD, VDP or other jacks, except the PHONO
input jacks. The television speakers can also be used
by connecting the television audio input jacks and the
player AUDIO OUT jacks. However, connection to a
stereo amplifier is recommended to obtain superior
audio
playback
quality for Compact
Discs
and
LaserDiscs.
Do not change
the television
antenna
and VCR
connections.
THE &]| MARK
System control can be performed when
the player is
combined
with an optional AV amplifier,
which
can
provide centralized control of Pioneer products with the
Gl mark.
Connect the VIDEO OUT jack of the player to the video
disc video input jack of the AV amplifier and connect
the AUDIO OUT jacks of the player to the audio input
jacks of the AV amplifier.
Connect the CONTROL
IN jack of the player to the
CONTROL
OUT
jack of the AV
amplifier
using a
commercially available cord with mini-plugs.
e For details concerning the connection and operation
methods, please refer to the operating instructions for
the AV amplifier.
)
ATTENUATOR
SWITCH
When the television speakers are used, the sound may
be distorted. In this case, set the ATTENUATOR
switch
to ON to reduce the distortion.
9
<VRB1163>
En
Advertisement
