Transportation, Storage And Disposal - Husqvarna LB 246PI Operator's Manual

3. Attach the battery to the engine, see
(LB 246PI) on page 9 .
To charge the battery
If only 1 or 0 lamp indicators on the battery are on, it is
necessary to charge it. An empty battery is fully charged
in 1 hour. To charge for shorter periods of time does not
do damage to the battery.
1. Put the battery in the battery charger.(Fig. 33 )
2. Connect the battery charger to a power socket,
220V, 50Hz.
Status for battery charge
LED display on the battery
LED 1 flashes
LED 1 is lit, LED 2 flashes
LED 1, LED 2 are lit, LED 3 flashes
LED 1, LED 2, LED 3 are lit, LED 4
flashes
LED 1, LED 2, LED 3, LED 4 are lit
Lamp indicator on the bat-
tery charger
Constant red light
Flashing red light
Constant green light
Flashing red and green
light
To clean the air filter
1. Remove the air filter cover and remove the filter.
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
12
Electrical start
Status
0%-25%
25%-50%
50%-75%
75%-100%
Fully charged
Status
The battery charges
The battery is too warm
and will start to charge
when the temperature is
correct
The battery is fully charg-
ed
The battery is damaged
and must be replaced

Transportation, storage and disposal

2. Hit the filter against a flat surface to make the
particles fall off.
CAUTION: Do not use solvent or
compressed air to clean the air filter.
3. Put the air filter back. Make sure that the air filter
fully seals against the air filter holder.
4. Put the air filter cover back.
Note: An air filter that is used for a long time cannot be
fully cleaned. Replace the air filter at regular intervals.
Always replace a damaged air filter.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, see
page 13 .(Fig. 34 )
• Replace the spark plug if it is necessary.
To examine the fuel system
• Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
• Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
Technical data on
287 - 004 - 21.11.2017