Sony KV-27V10 Service Manual page 27

2-7. PICTURE TUBE REMOVAL (2)
KV-27V10/27V15
(KV-32V15 only) © Picture tube shield assy
© Four tapping screws ats
K
@® C board
@ Anode pee Lie
+ REMOVAL OF ANODE-CAP
® Chassis assy
@ Deflection yoke
© Picture tube
Cushion
NOTE : Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT chield or carbon
painted on the CRT, after removing the anode.
+ REMOVING PROCEDURES
© Turn up one side of the rubber cap in the @ _Using a thumb pull up the rubber cap
direction indicated by the arrow @. firmly in the direction indicated by the
arrow ©.
+ HOW TO HANDLE AN ANODE-CAP
@® Don't hurt the surface of anode-caps with
sharp shaped material!
@® __ Don't press the rubber hardly not to hurt
inside of anode-caps!
A material fitting called as shatter-hook
terminal is built in the rubber.
@® _ Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or
hurt the rubber.
—7-
Anode button
@ When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning up
the rubber cap and pulling up it in the
direction of the arrow ©.
RM-Y117 RM-Y121/RM-CM101
KV-29V10C/29V10M/32V15
RM-YI17 | RM-Y117 RM-Y121
RM-CM10: