Sony KV-27V10 Service Manual page 26

KV-27V10/27V15
RM-Y117 RM-Y121/RM-CM101
KV-29V10C/29V10M/32V15
RM-Y117 RM-Y117 RM-Y121
RM-CM101
2-7. PICTURE TUBE REMOVAL (1)
(KV-27V10/27V15/29V10C/29V10M only)
Claw an
© Degaussing coil ———__{
a
@ C board
@ Deflection yoke
© Four tapping screws (7)
@ Anode cap
+ REMOVAL OF ANODE-CAP
@ Turn up one side of the rubber cap in the @ Using a thumb pull up the rubber cap
firmly in the direction indicated by the
-
we
al
© DGC holder (M)
q
@ Chassis assy
Wr)
> @® Tension spring J
painted on the CRT, after removing the anode.
* REMOVING PROCEDURES
direction indicated by the arrow @).
arrow ®.
* HOW TO HANDLE AN ANODE-CAP
®
@
Don't hurt the surface of anode-caps with
sharp shaped material!
Don't press the rubber hardly not to hurt
inside of anode-caps!
A material fitting called as shatter-hook
terminal is built in the rubber.
Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or
hurt the rubber.
— 2 —
@ Picture tube
Cushion
Anode button
© When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning up
the rubber cap and pulling up it in the
direction of the arrow ©.