Installation Instructions - Danby DCRM44WDB Owner's Use And Care Manual

Installation Instructions

LOCATION
DOOR REVERSAL
INSTRUCTIONS
• Ensure the appliance is unplugged and
empty.
• Adjust the 2 leveling feet to their
highest position.
Tools Required
Cross -bladed screw driver - Phillips
head
*NOTE:
- To take the door off it is necessary to
tilt the appliance backward.
- You should rest the appliance on
something solid e.g a chair just below
the top panel.
DO NOT lay the appliance completely
flat as this may damage the coolant
system.
Remove exterior and interior packaging, wipe the outside thoroughly with a
soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the
unit in a narrow recess or near any heat source, direct sunlight, or moisture.
Let air circulate freely around the unit. Keep the rear of the refrigerator 5
inches away from the wall.
Location
Do not tilt the refrigerator more than 45° from the upright position
during movement.
1) Select a place with a level surface.
2) Allow 5 inches of space between the back of the refrigerator and any
adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight may affect the acrylic
coating. Heat sources nearby will cause higher electricity consumption.
4)Avoid damp places. Too much moisture in the air will cause frost to
form very quickly on the evaporator, and your refrigerator will have to be
defrosted more frequently.
If you find the direction of opening the door on your appliance
inconvenient, you can change it by following the diagram below.
CAUTION
To avoid personal injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
St ep 1
St ep 3
4
St ep 2
St ep 4