6. Support 3.5mm left/right channel audio output.
7. Supports 180-degree rotation of HDMI1/2 display image in 2x2 mode
(when the upper displays installed upside down).
8. Firmware upgrading via micro USB port.
9. Lightning protection, surge protection, ESD protection.
10. Plug and play, no need to install drivers.
· Package Contents
Controller x1
Mounting ear
x2
Terminal Block
x1
· Panel Description
①
②
Power Adapter
User manual x1
5V/1A x1
Screw x6
Grounding
screw x1
③
④ ⑤
3
⑥
⑦
①
DC5V Power input
Connect with DC 5V/1A power adapter
②
HDMI signal input
Connect HDMI signal source
HDMI signal
③
Connect with HDMI splicing display devices
output x4
④
L/R audio output
Separate output of HDMI signal source audio
1) Press to restart the video wall controller;
2) Press and hold for 3 seconds to alternately realize
180° rotation of HDMI1/2 display image (in 2x2
mode, press and hold for 3 seconds to release
⑤
Reset
when the black screen occurs);
3) Press and hold for 10 seconds to restore factory
settings (wait until the power indicator is flashing
to release)
1) Steady on: The power is on
2) Slow flash: The transmitter and the receiver are
⑥
Power light
connected but no video data transmission
3) Quick flash: The factory settings have been
restored
Corresponding to 4 HDMI outputs respectively, the
HDMI signal light
⑦
indicator light of normal signal transmission is
x4
always on
Connect the computer for command control
⑧
Baud rate: 9600, Only when the dip switch is set to
RS-232
'111', the mode can be switched through RS-232
⑨
Mode switch
Switch splicing mode
⑩
Micro-USB port
Used for device firmware upgrading
⑧
⑨ ⑩
4