Advertisement
ETC Installation Guide
5" and 8" Touchscreen
Installation
1. The touchscreen universal mounting plate installs to a flush-mount
or surface-mount back box in either the portrait or landscape
orientation. The 5" touchscreen requires a standard 1-gang back
box and the 8" touchscreen requires a standard 2-gang back box.
Note:
minimum of a 49 mm hole. Use the appropriate mounting
hardware for your installation back box (UNC 6-32 screw for US
back box, M3.5 flat head screw for UK back box, or M3 hex head
screw for EU back box).
2. Connect the Ethernet cable to the RJ45 port receptacle on the rear
panel of the touchscreen.
3. Attach the touchscreen to the mounting plate.
a. Angle the touchscreen to the mounting plate at a 10 degree
clockwise angle where the keyholes on the touchscreen are
aligned to the locating lugs on the universal mounting plate.
b. Once all located lugs are seated to the touchscreen, rotate the
touchscreen 10 degrees counterclockwise, securing it in place.
5" and 8" Touchscreen
All flush-mount installations require a back box with a
Locating
Lugs (x4)
Page 3 of 4
ETC
Advertisement
