Table of Contents
Advertisement
Item
Applicable Model
Preparation
(1) Set signal generator output as
All White (Window ratio: 100%).
(2) Component signal (480i)
Video level : 0.700Vp-p
Sync level : 0.300Vp-p
Setup level : 0V
(3)
Check that Picture Menu is set as [RESET]
mode.
(4)
Set into Factory Adjustment mode.
Applicable Model
Preparation
(1)
Set signal generator output as All White
(Window ratio: 100%).
(2)
Component signal (480i)
Video level : 0.560Vp-p
Sync level : 0.286Vp-p
Setup level : 0V
(3)
Picture Menu is set to standard [Dynamic]
mode.
Set [Contrast mode] to [Normal].
(4)
Set into Factory Adjustment mode.
42PD8800/32LD8800
Video Color Temperature Adjustment (Warm)
42PD8800
32LD8800
Procedure
(1)
Perform the following adjustment with the remote
control.
(2)
Set the CRT Color Analyzer (CA100) at the center
of the panel.
(3)
Ensure that service adjustment
menu (submenu) No. 6, 7, 8 are all set as 255.
(4)
After receiving the video signal, step down
the two (or one) among adjustment No. 6, 7, 8 and
adjust the values as shown below.
(Note)
At least one of the data should be 255.
<Specification>
Video color Color temperature (Warm)
x=0.314 0.01
y=0.327 0.01
Procedure
(1)
Perform the following adjustment with remote
control.
(2)
Set the CRT Color Analyzer (CA-210) at the
center of the panel.
(3)
Ensure that Adjustment No. 6, 7, 8 of Service
Adjustment Menu (Sub) are all set as 230. If the
values are not 230, set them to 230.
(4)
After receiving the video signal, step down the two
(or one) among adjustment No. 6, 7, 8 and adjust
the values as shown below.
Note)
At least one of the data should be 255.
<Specification>
Video color Color temperature (Warm)
x=0.301 0.01
y=0.314 0.01
35
Advertisement
Table of Contents
