Fujitsu ASYG09LLCB Service Instruction page 54

1-4. Setting the Auto Restart
Enable or disable automatic system restart after a power outage.
Setting Description
Yes
No
*Auto restart is an emergency function such as for power failure etc. Do not start and stop the indoor
unit by this function in normal operation.
Be sure to operate by the control unit, or external input device.
1-5. Remote controller signal code
Change the indoor unit Signal Code, depending on the remote controllers.
Setting Description
A
B
C
D
1-6. Indoor unit fan control for energy saving (Only cooling mode)
Enable or disable indoor unit fan control when the outdoor unit is stopped.
Setting Description
No
Yes
* If setting value is "00" :
When the outdoor unit is stopped, the indoor unit fan operates following the setting on the
remote controller continuously.
* If setting value is "01" :
When the outdoor unit is stopped, the indoor unit fan operates at very low speed intermittently.
( Factory setting)
Function Number Setting Value
40
( Factory setting)
Function Number Setting Value
44
(
Function Number Setting Value
49
03-02
00
01
00
01
02
03
Factory setting)
00
01