Table of Contents
Advertisement
Available languages
Available languages
English
5. Reattach the top and bottom and firmly push the canister
back onto the sander.
Hints for optimum use (Fig. G)
•
Do not place your hands over the ventilation slots.
•
Do not exert too much pressure on the tool.
•
Regularly check the condition of the sanding sheet.
Replace when necessary.
•
Always sand with the grain of the wood.
•
When sanding new layers of paint before applying
another layer, use extra fine grit.
•
On very uneven surfaces, or when removing layers of
paint, start with a coarse grit. On other surfaces, start with
a medium grit. In both cases, gradually change to a fine
grit for a smooth finish.
•
When sanding on a vertical surface, hold the back handle
for better grip and control as shown in Fig. G.
2
Fig. G
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Repairs
The charger and battery pack are not serviceable.
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a BLACK+DECKER factory service
center or a BLACK+DECKER authorized service center.
Always use identical replacement parts.
6
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
•
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
•
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.blackanddecker.com/register.
ACCESSORIES
A variety of Mouse
Listings per retailer may vary. Note: Use only sandpaper
with holes in the same configuration as on the base of the
sander. Sandpaper without holes will not allow dust to enter
the canister.
The hook and loop pad and individual bases are replaceable
parts. If they become worn, contact your local service
center. For more information call: 1-800-544-6986.
2
APPLICATION / ACCESSORY MATRIX
ACCESSORY
Medium grit sandpaper
Fine grit sandpaper
Extra fine grit sandpaper
Detail sanding tips
1 OT polishing / stripping wool
4 OT fine polishing wool
Grey foam pad
White non-woven pad
Red non-woven pad
The pads described above may be available in kits where
Mouse® products are sold. For more information call
1-800-544-6986.
®
accessories are available at extra cost.
WARNING: The use of any accessory not
recommended for use with this appliance could
be hazardous.
RECOMMENDED
APPLICATIONS / USES
Paint, varnish, rust removal
Surface blending and finishing
Sanding between coats of paint
or varnish
Corners / hard to reach places
Polishing metals / stripping
varnish or urethane
Fine polishing, satin finish on
paint / varnish / urethane
Applying and removing polish
Light scrubbing
Heavy scrubbing / rust removal
Advertisement
Table of Contents
