Toshiba MV19L2 Service Manual page 13

2-18: CLUTCH ASS'Y (Refer to Fig. 2-18)
1. Remove the Capstan Brake Spring.
Remove the Polyslider Washer 1.
2.
3. Remove the Clutch Ass'y, Ring Spring and Coupling
Gear.
Unlock the 2 supports 2 and remove the Clutch Lever.
4.
Clutch Ass'y
Ring Spring
Coupling Gear
2
Clutch Lever
2-19: LOADING GEAR S/T ASS'Y (Refer to Fig. 2-19-A)
Remove the E-Ring 1 and remove the Main Loading
1.
Gear.
Slide the Main Rod and remove the Spring Holder.
2.
Remove the Main Rod, Tension Lever, Clutch Actuator,
3.
Idler Arm Ass'y.
Remove the screw 2.
4.
Remove the LED Reflecter.
5.
Remove the Loading Arm S Ass'y and Loading Arm T
6.
Ass'y.
7. Remove the Loading Gear S and Loading Gear T.
Remove the Loading Gear Spring.
8.
Main Rod
Idler Arm Ass'y
LED Reflecter
Clutch Actuator
• Screw Torque: 5 ± 0.5kgf•cm
DISASSEMBLY INSTRUCTIONS
1
Capstan Brake Spring
2
Fig. 2-18
Spring Holder
1
Main Loading Gear
Tension Lever
Loading Gear T
Loading Gear
2
Spring
Loading Arm T Ass'y
Loading Gear S
Loading Gear
Spring
Loading Arm S Ass'y
Fig. 2-19-A
NOTES
1. When you install the Loading Arm S Ass'y, Loading Arm
T Ass'y and Main Loading Gear, align each marker.
(Refer to Fig. 2-19-B)
Main Loading Gear
Marker
Loading Arm T Ass'y
2. When you install the Clutch Actuator, install as shown in
the circle of Fig. 2-19-C. (Refer to Fig. 2-19-C)
Clutch Actuator
2-20: INCLINED S/T ASS'Y (Refer to Fig. 2-20)
1. Remove the Cap P4.
Remove the screw 1.
2.
Unlock the support 2 and remove the Loading Gear
3.
Holder.
4. Remove the Inclined S Unit.
5. Remove the Inclined T Unit.
NOTE
Do not touch the roller of Guide Roller.
Inclined S Unit
• Screw Torque: 2.5 ± 0.5kgf•cm
Marker
Loading Arm S Ass'y
Fig. 2-19-B
Fig. 2-19-C
1
Loading Gear Holder
2
Inclined T Unit
Cap P4
Fig. 2-20