Belt clip installation
Install the clip as shown in the picture on the right. Do not use glue to attach the clip –
it may damage the battery.
On-ear headphone with mic installation
Insert the plug of the one-ear headphone with mic cable into the SP and MIC sockets as
shown in the picture on the right.
Battery installation
During installation, the battery must be held parallelly and fit the aluminum frame. The bottom of the
battery should be 1 to 2 cm below the shortwave radio's housing. Install the battery in the device ac-
cording to the graphic instructions below – just move the battery up parallelly until you hear a click.
To remove the battery (turn off the device before removing it), press the PUSH button, which releases
the latch, and slide the battery down.
Operation
Charging
It is recommended to use only a dedicated battery. The LED indicator shows the charging status of the
battery.
Charging status
Standby mode
Fully charged
Charging
Error
LED indicator
The red and green LEDs flash by turns.
The red LED is lit up.
The green LED is lit up.
The red and green LEDs flash by turns.
19
BAOFENG UV-5R
Instrukcja obsługi / User Manual